Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. bcooper2

    Incoming CLI on station display

    The way that I typically do this is through the public unknown numbering format assignments. This allows you to specify individual or ranges of extensions and the CLI sent across PRI trunks to the PSTN. Hope that helps.
  2. bcooper2

    DCS Question

    That is correct it does allow you to use a clear channel point to point circuit as a PRI. If you have a switch running anything below v12 on the definity you need to verify that you have PRI RTU. otherwise DCS plus is great and much easier to configure than tradition DCS where you have to...
  3. bcooper2

    Definity DS1 Card = 1 T1???

    That is correct the TN767 or TN464 T1 interface cards will only support 1 T1/DS1 or a E1 if you are in Europe. The interface on the switch will be through the anphenol connection on the back side of the carrier/gateway that the card is seated in. How you connect to the anphenol connection on...
  4. bcooper2

    Trunk Group errors

    If I remember correctly test 136 is for connectivity/signal from the carrier. You may have an outage due to a hard or soft loop on the circuit. I would ask AT&T to see if they can see a loop in the circuit and also verify connectivity from the NIU back to the PBX. I Could be wrong on this...
  5. bcooper2

    Calls Forwarded but Voicemail not answering

    When call forwarding calls to another extension in the switch the coverage path of the extension that you are forwarding to will not pick-up. Not sure if there is a work around on that one. Hope that helps!!

Part and Inventory Search

Back
Top