Search results for query: *

I am trying to install a product, Syn-Apps SA Announce, and one of the proceedures within the install require authentication with the publisher. Simply put in the IP of the publisher. Authentication fails. Syn-Apps says something is wrong with the CCM running 4.2.3, and Cisco claims something is...

That was the answer, thanks

I have added an additional subscriber to my network, however when attempting to join an existing publisher, which is CM_K8-PUB, it will not take this name or it's IP address. Says it's invalid characters "_", or cannot be an IP address. Anyone seen this or know a way around? Thanks.

I have the 6.1.2 ISO image but cannot figure out how to load it on the 6.1.3 loaded server.

Thanks,however, The customer no longer has the 6.1.2 disks. I also believe the customer loaded 6.1.3 from disk prior to me getting involved. Would opening a TAC case help my cause?

I have a real confusing problem. I have a current install of publisher and subscriber. The customer ordered an additional subscriber, however, the software he ordered with it is 6.1.3. His current cluster is at 6.1.2. I obtained a 6.1.2 iso image but cannot figure out how to downgrade from...

The users are all the same and I ran permissions wizard and had no problems. It appears Unity thinks these users with problems already have an assignment in Unity, but they do not.

Unity Version 4.2(1.0). Not the AD on unity. I was speaking of the exchange server.

Yes,I am confused also. Most of my users work fine with changes in active directory. Only a handful do not work. maybe in trying to get it to work, I hosed the database. Shall I delete the user in Unity and wait for the AD to update?

CCM 4.1 and 2000 exchange. Do I need to config MLA for true?

I have run into a situation where some of my users, who I change extensions in Callmanager and delete them from Unity, will not be found via the active directory when trying to add them back into Unity. Only some users, not all. Does anyone know of a few things to check to correct this problem...

How can I upgrade from 4.2.3 to 7.1.2 without a bootable disk. Can this be done with an ISO disk? Thanks

I am upgrading for 6.1. So, this being an upgrade, I should be able to download the two files from CCO, conbine tem per the doc onto one disk, flip it in the drive and perform the upgrade???

We are trying to order CCM 7.0 and received license disks instead. I there a way to get the software online? Thanks

Trying to update my 7911 for voice mail and ASCII test display, however, I cannot get past this error message. This is an update process. Should I be doing a phone add instead. Thanks.

I have a route group and pattern 72 that goes out a VGW FXO port to the Bogen. It's ground start on the gateway and Bogen. I dial 72 than it should give me a tone to enter the zone to page, however, no tone and no response when I enter a zone number.

Yes, I was brain dead. All is working great. Thanks for your help.

I am missing something here. I have a DN and want to forward to a hunt (have a pilot#), but where in the phone/DN settings do I specify the pilot number? I try the ring no answer option with the pilot #, but it never goes there. Help

I cannot seem to make a Bogen PCM 2000 paging to work on a 2811 VGW running 12.4(25a). Can anyone tell me if this will work on the current IOS, or do I need to downgrade. Thanks.

I am planning an upgrade from CCM 4.2(3) to 7.0(2) and wondered if there is a specific DMA release to use? Thanks