Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. nawlins

    Decode / Interpret each field of Level-2 D-channel monitoring, i.e. "interface ID" etc

    Anyone have a document or decoder tool to interpret the HEX output of Level-2 DCH monitoring?
  2. nawlins

    AUD083 and VM MWI stops working ...

    Here's and example of the error: % AUD083 072BFB19 00000c88 00000000 00000000 00000000 00000000 00000000 0000000D 00000000 % 00000000 00000000 00000000 00000F06 No sure however does the 0c88 have relevance to a channel in trouble (12_0_2_8) ???
  3. nawlins

    AUD083 and VM MWI stops working ...

    Callpilot platform 1005r Ver 5.00.41 CS1000 MG 5.5 Sporadic events occur where the CS1K starts spitting out AUD083 and MWI stops working. Quick fix is a reset on the DCH(s) and all is well. Two routes exist going to separate Cisco clusters for VoIP. Each route consists of 4 PRI, yet only...
  4. nawlins

    Program "pause" on HOT D for zone access to Valcom Paging

    Unfortunately I've attempted all of the above without success. It seems to me from a digital set there is a longer delay than from analog before I can send DTMF to the valcom for zone selection. If I pick up the handset on the 39xx and dial slowly (very lol) I can cut through to the zone and...
  5. nawlins

    Program "pause" on HOT D for zone access to Valcom Paging

    System is CS1K Rls 6.0 I changed the rout and trunk from cot to wat. The *1 after the access code is not recognized by the Valcom and I just receive the Valcom tone. Tried as autodial and same results.

Part and Inventory Search

Back
Top