Search results for query: *

Call Extreme and Replace it. It's a x450e-48p. Extreme has a Life long warranty for all Edge switches. It's just a Return and Replace. I'm a Extreme Tech :)

How many vlans do you have with ipforwarding enabled? If none are you can easily enable ipforwarding on both vlans and add IP's to forward between them. If you have other vlans with ipforwarding you will have to create new VR's but Extremeware doesn't support the creation of a new Vr

If you cant get into the bootrom or bootstrap it will need to be replaced.

Yep is sure is. u just cant do it across modules

If the DHCP works for a PC and not a Phone it looks like the switch is configured correctly. Extreme DHCP doesn't always work for every device becasue it was added to the code for testing and was not made to support a production network. I would check to see if there is a new firmware for the...

How much power are you using? #show inline-power Are you getting any POE errors in your logs? Extreme switches default to allowing 70% for POE power. You can change this to 90% with the below command. #configure inline-power usage-threshold 90 Let me know if this helps.

it's enable web http or enable web https

yes it is a CLI command. but my mistake i see that it is a 6808 and it's not EXOS. show power is a EXOS command. I would run diags. MSM-A looks like it could be failing. I would run it with only with MSM-A in the Chassis. If the MSM failed over the logs could be false positive. You could...

entry block_TELNET { if { protocol 6; source-address 192.168.11.10/32; destination-port 23; } then { deny; } } save this to a .pol file and add the .pol file to the vlan

You can also use the back door password :)

entry block_TELNET { if { protocol 6; source-address 192.168.11.10/32; destination-port 23; } then { deny; } } Protocol 6 is TCP Welcome :)

clear log diag-status is all you need to do. and reboot

Try doing Show Power Budget and see is your N+. this is redundant. 1. Did the MSM fail over? 2. You can try failing over to MSM-B and running Diags on A this is non-intrusive to check for HW failure. Welcome :)