Search results for query: *

Based on what you stated, this is all you'll need. If ever you get into projects that require actual certification, just rent the tester, or sub it out...

No biggie, it just needs a perm.

Thanks for all of your input. Defected Combo DS card in slot 2. It was indeed flaky joe.

DS port on a base card.

Let's say I'm 90% sure, and I'm wrong. The trouble that I described can only exist due to a PC in the port?

No PC was ever in the port.

Didn't work. I'll be back at it today. Any additional recommendations would be appreciated. Regards

Thanks hold. I'll give it a go, and let you know.

Have a system that boots up, performs checksum then all of the telephones (1416) power down completely, but the control unit stays powered. I'm able to dial into the system, the AA answers and routes the call accordingly. The call goes directly to VM because the phones have no power. What could...

Customer has embedded VM. All incoming calls are picked up by AA1. The AA plays and asks the caller to leave a message. Approximately one second after the AA ends, the call drops. You hear the beep to begin recording your message, one second after, the three audible tones ending the message...

I have IPO, 8 but want to use Essential without upgrading. I was instructed to roll back to 7.0(32). Is there any difference between 7.0(32) and 7.0(36)? Also if I downgrade to 7, will upgrading back to my original state require I purchase a license? Best regards

The customer has decided to upgrade to an Avaya IP Office. Again, thanks for your input.

I'll put this to work next week, and post my outcome. Thank you much

I pulled these instructions from another thread; are they correct? Testing Touch-Tone Receivers The 016 (T/R), 016 ETR, 400 GS/LS, and 412 LS-ID-TDL modules each provide four touch-tone receivers (TTRs). The 008 OPT, 012 T/R, 800 DID, 800 GS/LS-ID and MERLIN Messaging System modules each...

Thanks Tim, I'll follow up with this tomorrow.

We have a Merlin 7 system with AA programmed to answer and route all incoming calls. The following has been occurring intermittently for the past 3 weeks: - Incoming calls are answered by the AA, but are told the mailbox(es)is full, when they aren't. - Incoming calls are not being answered by...

Thanks guys. So I70 should work straight away, or would I need to assign extensions to a group?

When *70 is dialed at any extension, there is a busy signal. What could be causing this? Avaya Partner R6 308EC (1) 18D (6) 6D Thanks

Sorry I didn't elaborate. It's the on-hold tone that's heard over the telephone's speaker.

Can anyone recommend a conference phone that works well with Avaya Partner R6. Regards