Search results for query: *

So you need access to the pep's above or if some one still has them download?

Yes i checked the event codes it just says reboot system and contact local support group The hard drive was my first choice for trying to replace any equipment at this time. thanks

I have a bcm 450 on release 6.0 has the last patches available thru Avaya issue. The voicemail service stops unexpectedly event code 10102 and 10002 . You can manually restart the service and about hour stops again. Any suggestions. thanks

thanks for your help on this

If the system has expansion modules do you need to connect them up first to restore or can you just load backup on the newer main chassis after installing the patches. thank for your time

can you use the backup from one system same release to another or is their a serial number attached to the backup?

Booting up bcm 450 with multi image drive getting error message unable to read bcm450.safeos.initrd then unable to read bmbimage from ide 0:1 does not finish bootup I have attached bootup text file 1 Storage Device(s) found reading bmbImage ** Unable to read "bmbImage" from ide 0:1 ** reading...

Does the qpc841 card just need power from the back plan . Can it go to the right or left side of a super loop card slot?

I would think that only the vantage handsets would be supported or work on this system . I can not believe it is still working or in working order . I have not seen one since the early 1990's

Got support thru right fax was able to set up as regular t1 esf b8zs and em 4 wnk wnk set right fax to t1 cas setting and right fax needs cas table installed on ther righ fax server for this to work. Don't try ni2 did will not work can not tandem calls or dial outbound with this configuration

I found and old thread thread798-1268715 that references the same problem that iam having solution was design intent. I can not confirm this from listed document 553-2901-100 isdn not sure if any one on this forum can confirm also. I have checked on the Avaya web site but have not found...

I have been trying to get the RightFax open text 2100 to connect to cs1000m I have read several posts on this forum first try was old school with plain t-1 with em4. Appears you get not good documention from righfax . Had it working with ni2 and did internally but could work or answer but could...

Many thanks bignose21 for the update I appreciate it

Do you know if it is possible to get a merlin legend model 511a to do kari's law dialing?

Thanks for the update on this

Does any one no of limitations to installing two nt5d12 cards in same ce shelf back to back i.e. loops 8,9 and 10,11 is this possible?

bignose21 if you can find or confirm steps that would be great or any one else for that matter. thanks everyone for the update post. And yes kcflhrc it is to be cautious when entering pdt area.

bignose21 can you load the license file via ucm this vx works I could not find any place to do it I no you can on co res machine

kman would be ok if you still got the paper copy of the codes, on the xmodem transfer to cf2 or to the directory location?

Does any one have the steps to remote in to cs 1000m via a modem and transfer the keycode files I have been using procom to attempt this . thanks