Search results for query: *

Wake-up call?

Form 19? Call re-routing.

I'm clear at the bottom. Could you be more specific? 280 shows device interconnection table.

Thank you for your continued help!

Erased the phone and re-programmed as a 5312 bare bones. Now it has no MAC address nor does it show having an IP address, but it rings and is idle now!?

I wonder, if I erase the extension and re-program it, will it be assigned a new DHCP address that I could then change remotely to static and permanent?

Thanks, I will give that a shot!

SX-200 ICP, and I don't think MDUG applies, thanks.

I have a 5312 set that has been replaced twice, and is locked. Have released it in maint, but after answering call, reverts to locked status.

Went in through the phone, edited mailbox 0, gave it a new password, changed the extension back to 0, (had it going to ext 550 sub att because it has a generic greeting for the hotel. Problem mailbox is now deleted, bit when getting transferred to voice mail from a phone, I still get the name...

Checked, and no, as far as form 19 goes.

By done I mean checked. That's the way it was/is set. Form 19 nothing unusual, just set for LDN keys. I'll try again to listen to the "0" name. Seems like that wasn't an option, nor is deleting it and re-programming it.

Yes, there is a call staus in maintenance. By extension, trunk, software id, and show status all. Call shows ringing extension, then goes to idle after it forwards, doesn't show where it forwards to, however, but it forwards to operator mailbox, even though it says the GM's name.

Done. "0" is transfer only, and the extension is "0".

All overseas area codes are denied, I have the list. Calls are not going off-site, Dial "0" calls are getting the actual GM's mailbox name.

GM mailbox name has highjacked the operators default mailbox name, so upon cfna or dial "0", you get the GM name instead of "you are being transferred to the operator". Checked all fwding and re-routing.

SX200 ICP general manager's recorded name for his mailbox has "highjacked" the default "The operator" when transferred to same. So when I reach the AA and dial "0", I get "you are being transferred to: "Adam Johnson". CFNA system wide is met with same.

SX 200 MX, no I haven't tried that. It's a remote site.

CO Line keys

Have a couple 5330 sets that stopped ringing on CO Line keys, but will ring when someone calls it's extension. Also no blinking line key light either, so not volume.