Search results for query: *

Hi, I suggest that you check your spanning-tree configuration (should be active on MLT but not on ports ; in normal learning mode), as well as your interfaces configuration (speed / duplex - should be the same on all interfaces within the MLT, on both sides). Cheers, y/

No sorry, my mistake ... this is for secure versions requiring login + password. Just try rwa, or secure, as a password. Cheers, y/

Hi, Try RW / secure. Cheers, y/

Hi, Which software release ? Cheers, y/

Hi Manz, I'm not sure it works this way. The Cisco IOS software attempts authorization with the next listed method only when there is no response from the previous method. If authorization fails at any point in this cycle—meaning that the security server or local username database responds by...

Thanks for the feedback, nice to hear some good news :)

Prompt for tacacs is displayed as tacacs authentication is configured. There's no check for the authentication server being alive or not before the prompt is displayed. And to answer your question, yes it's your loopback 10 interface that is used for all the traffic between your device and the...

Hi, I think that you should state which interface is inside (Fa0 -> 3) and outside (Fa4), and use ip nat inside commands. Cheers, y/

Hi, No there's no need for advanced licence in order to perform traffic filtering. I usually rather use the ip traffic-filter feature for this purpose. ip traffic-filter create global src-ip 10.1.30.0/255.255.255.0 dst-ip 10.1.31.0/255.255.255.0 id 255 ip traffic-filter 255 action mode drop...

Hi, What's the purpose of negating a NAT rule ? What's not declared in NAT rules isn't translated, that's the default behaviour ..... Cheers, y/

Hi, Yes you can add your switches without causing an outage. Just ensure before that : - the new devices run the same diag+firmware version as the stack, - the new devices aren't setup to become base units (check the switch on the back panel). I also recommend you to restart your new devices...

Hi, <ADDR1> is the IP address of your Nortel device in the users VLAN. Cheers, y/

Hi, If I remember well, you have to disable your MLT before adding / removing a port from it. Once the change is done you can enable the MLT again. Cheers, y/

Hi, You can set it up by running the following command : P8610-1:5# config cli banner ? Sub-Context: Current Context: add <string> defaultbanner <true|false> delete info Cheers, y/

Hi Motiv, When your problem occurs, I understand that you can't reach some websites through your internet browser ; am I right ? Do you have tested some more sites at this time, are there some that you can reach in the same time ? Did you try to do ipconfig /flushdns when this occurs ? You say...

Hi Eksantrik, Doesn't the show qos statistics <policy number> give you the information you want ? You should see the Total In-Profile Packets increase while traffic goes through the switch. Regards, yaoul

Hi Sakult, Aren't ERS5530 layer 3 devices ? Then, why would you have STP configured between those switches and the Passport devices ? MSTP could be useful when the VLANs carried over your equipments include a high number of user ports. You could then configure several STGs in order to reduce...

Sorry I forgot the feedback. I found no operation to solve the problem. The switches are on the way back to the vendor at whom I opened a case. Thanks for your help.

Ok I'll try it tomorrow and keep you informed. Thanks for your help. Yaoul

Hi again, Thanks for your answers and suggestions. All the switches I had to upgrade for this time were standalone ones, no stack. I've configured a static IP on each switch AND on my laptop, all the addresses being of course in the same subnet. The switches are not yet in use, so they are not...