Search results for query: *

you are welcome, even with target 2 it should work also .

Hey, yes of course you can do it . Manager E : incoming calls -> call forwarding, choose a list number for day/night/intern-> go to that number and make the target 1, with "an external destination" .

hey guys, i have a weird problem regarding the cards and the base station we installed a new OSB x8 with one extension box 11 slma24 2 slmu 4 slmuc 1 diut2 34 base station 7 LUNA my problem is some of the base station are not working almost the half, and sometimes one of the SLMUC dect card...

you have to use hipath CardManager .

which system and which card ?!

OK, did you configure the IP default router on your OSB !

first, did you do the upgrade properly ? did you try to ping the new control card directly from your PC ?

Try to go here and set up the right time, Setup - Wizards - Basic Installation - Initial Installation

thank you very much guys for everything you did, i can confirm now the modules were faulty .

i just had this answer from our support, "It may be also that the Access modules you acquired are delivered more or less in the March 2018 time frame?? There is a problem ticket NA15837629 that was found out that there’s a problem with the FW of this module. " can anybody confirm this...

yes of course here is the credential of the teamviewer ID: 498 724 892 PSW: 3888

@Moriendi yes it should connect directly but just to see the packets with wireshark i used a switch in between . @hipath4k yes i already did this .

. yes i've tried all of them and none work . . this is the last loadware from the partner portal Spec_LW_V8_R1_19_7 Pilot Usage 2018-08-23 . . i just did exactly what you said, mirroring on the switch for each module the "new" and the "old" PRI, the defect PRI is acting exactly like the ready...

@Moriendi maybe the MAC address for one PRI was wrong, but i do have 6 PRI .

@sbcsu here is the creation and the display of the bcsu . ADD-BCSU:MTYPE=DIU,LTG=1,LTU=30,SLOT=15,PARTNO="Q2335-X",LWVAR="0",FCTID=1,HWYBD L=A,ALARMNO=0,MACADDR=00-1A-E8-3D-4B-70,TDMLAW=0; ADD-BCSU:MTYPE=DIU,LTG=1,LTU=30,SLOT=15,PARTNO="Q2335-X",LWVAR="0",FCTID=1...

Hey Guys ! i couldn't connect my new Openscape Access PRI mdoule (S30807-U6648-X170-16) to the Openscape 4000 Branch (V8 R1.19) , dis-bcsu -> it shows me "defect" . but when i use an old hipath access PRI module (S30807-U6648-X170-12 ) with the same configuration & the same OS branch...

Hello everyone, I couldn't receive a FAX in my fax box, through analog trunk (TMANI) ,knowing that sending with fax printer works well. Do you guys have any idea what is the problem of this situation ?! Thank you in advance !

wanna share with you this, i found that IPv6 will be implemented in OS4K V9 and on V8 can be used only for the interconnexion with softgate.

Hey guys, Can you tell me if the unify pbx (OSBiz, OS4K) work fine with IPV6 ?? for the phones i know the CP600 can be configured with it . Regards,

for internal calls, i think you can not .