Search results for query: *

Are you getting an error message from NRU about not finding the file? If so, what file is it looking for?

Ok, I've sent several to you, let me know if you need any other ones.

Post your email address and I'll send the ones I have

I have a sticker that says pm 8.4 near voice cards and one that says pm04h1 near power supply

You're right of course, but to me the question sounded more like an end user wanting to have access to line 4 without the help of a vendor and not that much information. Although if he already had an appearance for line 4 then he can easily move the button following your instructions

You'll need to change the line assignment on this set to appear and ring. Enter Feature **Config Password: config The display will show Terminals and Sets and you'll see three triangles next to your buttons, press the upper right one to select terminals and sets. Enter the extension number...

As far as I know one of the main advantages of a PRI over T1 is that you can dynamically allocate the channels as inbound / outbound whereas with a voice T1 they have to allocated as one or the other.

I have a pc based Partner Mail and I'm not familiar with these at all. Is there more than one version, if so how can I find out what version it is?

Yes, enter programming mode, goto the set that autmatically selects a line, select line access, navigate right a few times to where it says prime line, it should say either none, i/c, pool a-? or line 001-? go back to the extension you want to change and make it match the one that works This...

These are both very simple changes, here's a walk through: This must be done from an M7310, M7423 or T7316 phone Feature **config The default password is config The display will show Terminals and Sets And you'll notice that there will be three triangles next to your buttons. The bottom...

For each set that you want caller id information automatically shown you need to enable it for each line that has an appearance on that set. Under the programming for each set go to telco features -> feature assign and change Call Log Set to yes for each line.

SIIG makes a USB to Serial adapter, http://www.siig.com I was able to pick one up locally at Fry's Electronics.