Search results for query: *

Found IT!!! Thanks for the help.

I am trying to set up hunt groups for a specific companies. However, when attempting to do so, all of my (LSNO,<SCH 442>) Next List Numbers are used. I noticed that the 300 List numbers are used in the SCL Table. How do I delete some SCL Tables so they are available for group hunting. I...

This is an option 61c - Rel 4.0

Hi folks We are now calling folks outside of the US. I will be calling a lot of Germany numbers. Therefore, I need to open the LD access to call these numbers. Unfamiliar teritory for me. When I dial a "9 0" I get a busy signal. the number I am trying to call is 001 49 2433 XXXX. Any ideas...

Thanks John I will definitely need help with that. We'll hook up with some ideas soon.

Good morning all. I am having several complaints about fax spamming and telemarketing calls throughout our system. I have asked the folks to write down the number and hand it over to me. I have them. At first I set up an IDC table and sent them to a busy signal (non used DN) however I found...

I have an option 61C using 3903, 3904, and IP (I2004) phones. The 3903 and 3904 telephones (DIGITAL) detect caller ID Name and Number properly. However The IP phones only display phone number NOT NAME. Have I missed a setting on these pones or is this feature not available yet? We are paying...

Thanks John I'll go from there Mike S.

I have a question. I currenty operate an Option 61C with Call Pilot 3.0. Due to some changes in my auto attendant, I have a phone with a voice mail attached (5755). However, due to some auto attendant changes, I built a phantom TN (5064 number) with a general mailbox that can be accessed by...

Are you using BCMs? If so go to Services...Telephony Services......System DNs...............Active Set DNs..........Line access.......Line assignment.... highlight the line and click y for caller ID set. This should take care of it.

Bucky Funny you wrote I just placed a BCM in yesterday and the same issue has risen. Check it out!!! I was to start this thread. I haven't completely read all replies but I will now. I have seven bcm's in my phone network all which tie back into a 61c which has four PRIs to the PSTN...

I have seven bcm's in my phone network all which tie back into a 61c which has four PRIs to the PSTN. Currently we have installed a new BCM 3.7 (total 8) and the OLI is not functioning properly. At the line access prompt, I have placed my 4 digit extension in the private oli index and my 10...

Hi folks I purchased a Nortel 5520 switch and configured it. I can see the switch in my optivity switch network and can commujnicate with it via telenet. I can bring the switch up as I do with all other swithes in my network. However the switch shows in large bold letters "UNIT DOWN" and the...

I have an option 61c and I can not find the "ld XX" needed to change the time on my telephones they have all drifted seven minutes. Any suggestions

I have a Nortel Option 61c PBX. A few users want to block all incoming calls not having Caller ID, or mainly those who block their incoming phone number. I thought I could do this in the CLS, however I can not find the associated Acronym to turn this feature on/off. I wnat to use this feature...

I have an option 61C and a few users want to block all incoming calls not having caller ID, or mainly those who blocking their number. I thought it was in the CLS but I can not find the associated Acronym. I want to use this feature on a Per user basis not on the entire PRI. Any Suggestions?