Thanks Frank,
No need to post the config as the concentrator is working fine I was just tring to get a better understanding of what the logs mean.
Regards, and Merry Christmas.
The line in question reads:
5 10:22:22.071 11/23/05 Sev=Info/4 CM/0x63100024
Attempt connection with server "xxx.xxx.xxx.xxx"
There are other lines that read for example:
8 10:22:22.121 11/23/05 Sev=Info/4 IKE/0x63000013
SENDING >>> ISAKMP OAK MM (SA, VID(Xauth), VID(dpd)...
Can anyone confirm that lines in Cisco VPN client logs with a reference such as CM/0x63100024 refer to "Crypto Map"? Can anyone point me in the direction of a good document that helps understand these logs?
Many Thanks
When DFM discovers my devices it makes loads of mistakes, for example it lists Dial on Demand circuits as megastreams and such therefore generating loads of false errors in the console. I changed the circuit types and other errors in the Administration Console but then when autodiscovery takes...
I am trying to block SNMP and SNMP Trap comming into my network from a connected site, but the traffic comes in on what appears to be changing port numbers although the destination ports 161 and 162 are the same. Can I write an access list based on the destination port of a packet when the...
Have you re-installed Java on the client? if not remove via add/remove programmes in control panel, then the next time you point your browser at the CW server it should re-install the latest version for you.
Problem within CWorks with the bundled Verisign software. The solution was to upgrade the version of Java installed, we are now running JRE 1.2.2 Version 2.0 on the server, client 1.3.1 on the desktop.
Hi,
I am having problems with Cisco Works2000 and TACACS, when I try and check attributes (or similar) of devices on my network using TACACS for AAA under the telnet header and TACACS header in the report generated it says "not supported" and under the Enable and TACACS enable hearder...
Don,
Am using TACACS for authentication to all our Cisco routers and switches on our network. Once authenticated to the router or switch all commands entered apply to that device don't they? or is there a command to change my TACACS password?
Thanks for your help so far...
Ali
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.