Recent content by WrongWayFeldman

Single Number reach may work for you. You could make the departmental line a hunt group pilot. Then add phone users to a hunt list where they login/logout as needed.

https://community.cisco.com/t5/unified-communications/unregistered-phone-report/td-p/1664735

Cisco Unified CM Administration System version: 10.5.2.12901-1 I have two clusters where both use SIP trunks from the same carrier. The issue is that ringback from blind transferred calls to an external phone number on cluster "A" is not heard by the calling party. Cluster "B" works as it...

Do you know the part numbers for an AC Power supply and a DC power supply so I can look up some pictures? Also, do you know where I can rent a monkey?

Shouldn’t I INI both sides so that if the CPU switched it would still work? Also can you INI the inactive side or do you have to make it active first?

That's funny, I actually did. They could not even come close to what I make now. Thanks for the suggestion though. I would not leave where I work now for less than 90K.

Thanks for you input. I plan to change the OPD "out pulse digits setting" in the RDB. According to the software IO guide, you have to INI the PBX before the change will take affect. I'm assuming I would need to INI both. Does the INI both command actually INI both at the same time or does it...

How can I tell if a cs1000 is an AC switch or a DC switch from command line in a telnet session to the PBX?

Can someone provide step by step instructions on how to INI both the CS1000 and C1000E PBX? Both are on release 7.6. Can anyone refer me to an NTP that explains the process?

How can I tell if a cs1000 is an AC switch or a DC switch from command line in a telnet session to the PBX?

Can anybody explain the lockout to me? I was in LD 80 tracing call to a fax server that uses analog 500 ports off of our CS1000M Rel 7.5. I can see after the call completes, the port will go into lockout state for a short period before it goes idle. It doesn't do this all the time. What does...

I'm working on a cs1000 release 7.5. Does anyone know how (via command line) to identify all system monitor boards and the loops that they are associated with? Also, is there any kind of STAT command I can run to see if they are working?

I love Tek-Tips! This is the only place I know where idiots like me can get information explained in a way my pea brain can understand. Thanks to anyone who replies! Can anyone help me understand the pieces and parts that I would need to connect my Avaya cs1000e (7.6) to a PSTN SIP Trunk? I...

I should have know that. I need to get out of my office and spend more time in the switch room. Thanks for the reply.

Is a net work card and a controller card the same thing? What is the part number for a network card?