Recent content by Wooliepride

I have all the necessary hardware (2GB RAM---40GB HD) Confused as to the install process. Do I need both the 7.5 Linux and the 7.5 CS Install RMD's? My thoughts were to install the 7.5 Linux and then add CS (keycodes) through UCM but not sure. Also do I need FMD on the CPPM in addition to the HD...

Thanks. We sent out 2-DK70BB's (they are labeled BB) and the customer is stating they are DK70AA's. I have no idea how to find this out or how the customer knows, thus this post.

Is there any way to identify the part # of the power card in 11C? Have tried inv generate/ inv prt in LD 117 with no results. Any one know of another way to get this info? Thank you

I'm new to Samsung. Trying to backup VM and keep getting "Failed to connect to FTP server". Have done this successfully on OS7100 but having this issue on 7030. Thanks for your help.

Can you use Rls. 4.5 sig server software on a NTDW66 card? Thank you

New to these systems. When processor boots, is there a way to stop "SVM started" ringing on sets? Thank you

Kstaff22 is correct. The 54 will boot to screen without a HD just like any other server. Pull the HD and boot, you should get something on screen, if not card is bad or bad memory.

I have been unable to locate a list of memory size for the different nomenclature's on the CPDC and CPMG cards. They both have AA,AB,BA,BB version's but like I said, I cannot locate the difference in memory size between the different version's. Any help is appreciated and thank you.

Well I was hoping for better news. Thanks for the link.

Is there any way to assign the TLAN IP address to the daughterboard through CLI? Normally this is done through UCM/Element Manager but I cannot access (long story). Running 7.5 and looking to assign TLAN IP to 2 -NTDW64 DB's on NTDW20-MGX card. Thank you

Installing a 7.5 (SA) CPPM in DU14 chassis. Can we make the 1 CPPM card the UCM, CS and Sig server? (We have MGC card as well). If so is all programming done after installing Linux on CPPM and then adding Call Server/key codes through UCM? Do we need CPDC card? Thanks

Getting these errors; On Main Board-interrupt error: MGX Cardlan access is seized by other side 1 On Daughter board- The card lan is seized forcibly These errors occur after a successful upgrade. I've swapped out FMD's and the errors still occur after upgrade. I'm guessing hardware but don't...

I believe it's an address and doesn't really matter what slot you put it in. I think I remember it can be addresses from 0-15.

I know the DW66 is only to be used as a Sig Server. Why would you want to use the DW99 in an IPE module?

I'm trying to restore a backup via USB and just can't seem to find the proper prompt in Linux. My access to UCM is not working currently (long story) so I need to do this through Linux (CLI). Any help is appreciated. Thanks