Recent content by ttrsux

Brand new Cisco ASA 5506-X. Ran the VPN wizard to enable Remote Access VPN with the Cisco VPN Client. At the end, all is "OK" except an error: Error: crypto ikev1 enable outside failed to open "udp/localized/2/4500" Error: Error opening IKE port 4500 on Interface outside Can someone help me...

Does this affect many websites at Site A? No. Just one website in particular. Has been this way ever since switching from Comcast to Fiber. We are almost to the point where we are going to assign an entire new IP block to the customer because of this. We contacted the ISP for fiber and this is...

I forgot to mention there is a Cisco ASA 5510 on each side of the VPN tunnel.

We have two sites -- A and B -- connected via a persistent IPSEC VPN tunnel. Site A is trying to get to a website but it takes almost a minute to load. Site B can get to the site just fine. The page loads instantly. Is there a way I can make requests in site A for this URL go through...

Last question. I just want to clarify what "nat (inside-wlan) 1 0.0.0.0 0.0.0.0" actually did. Is it basically creating a default route for that interface, and does 1 represent the "pool ID"? Many thanks again. I have been posting on Cisco forums for months but I just get drive-by "try...

YOU THE MAN iggsterman. IT WORKED! My palms are sweating, it's been MONTHS! Many, many thanks! :D

Wow! Thanks for the quick reply iggsterman. Should I remove the second static line then, or leave it and add the nat line? I can ping the gateway from the 192.168.100.1 network. From what I understand if I make the security level the same on eth0/2 (100, just like eth0/1), it's technically not...

I have an ASA 5510 and just configured eth0/2 as 192.168.200.1 to expand my network -- I would like to just put all the wireless access points on this new network. I don't have much CLI experience but have been using ASDM for the last couple years and have managed to figure out how to do quite a...

Hello, My building has two internet connections, fiber and Comcast. I have a computer plugged into the Comcast and assigned a public IP to it. I copy files from this computer to a server behind a firewall on the fiber, in the same building. The transfer rate is very low and I was wondering if...

Thanks ShackDaddy! I agree, a flat domain structure is always nice. I tried to demote the server dc.subdomain.domain.local and got an error immediately after it started: "8614 The directory service cannot replicate with this server because the time since the last replication with this server...

[bump] ♫♪ hello hello helloooooo is there anybody out there.... just nod if you can hear me.... ♪♫ [hippy]

I forgot to mention, AD Sites and Services is currently set up so I imagine I'd need to decommission it or remove the site from the main site's side first? Not sure how to "turn off" AD Sites and Services properly. Can I just go into the snap-in and delete the west coast site?

Hello all, I have two sites connected via persistent site-to-site VPN. West Coast is the "main" site --> domain.local East Coast is the "remote" site --> subdomain.domain.local For some reason, the remote site was created as a subdomain and a DC was put in place as dc.subdomain.domain.local...

sigh...

On my Exchange 2003 server, I access OWA using http://servername/exchange/administrator/. If I replace administrator with another username, I am prompted for credentials even though I have full control over the "server" in Exchange System Manager AND the Mailbox Store -- both are FULL CONTROL...