Recent content by tgoldsmith

When you look in CC Web and select status, does it say the same even though it is running? If so select configuration, then select that server, then select server then refresh and it should clear this.

Well 1140's should ne programmed as 1140's and 1110 should be programmed as 1110's. Maybe your software is older. Try type as 2001p2.

I had the same issue where calls leaving a pri were being rejected due to the Numbering plan. Had the vendor/PRI provider chnge the number plan option and calls finally were sent out.

I suggest replacing the Conf/TDS pack in the same Net/Group of the dtmf issues.

He was asking about hardware not software.

Do a search for putty or ZOC? These will allow you to use Ssh, If you know the UCM site address you can use Inetenet Explorer.

Yes this will work on both internal and external. You should be good to go.

TARG/TGAR are not levels . If you want to block a phone from a route ACOD then you match the TGAR and the TARG. IF you want to allow it then you make it different. Someone correct me if I am wrong.

I believe you need to change the TGAR not to match the TARG on the Paging route.

This is not true. The phone makes it full duplex not the line. Polycom Soundstation 2 conference phone- Full duplex- Voice quality like the Polycom Premier- Includes a 2.5mm jack for connection to other communication devices (mobile phones, etc.). Caller ID and phonebook- 25# Phonebook/speed...

So is in dch 10 that has the loops in lockout?

That is an analog phone just template it to a 500 set.

Here is the link for the hardware EOL. Link

No because if either phone has a call reach voicemail, the voicemail will pick up the id of the originating dialed number and send it to the correct mailbox.

LD 60 dsch (loop) (channel) ench (loop) (channel) If they keep going in lock out it could be the other end of the PRI.