Recent content by SteveBUK

Hi avps70, Below is the link for the software. Regards Stevehttp://files.engineering.com/getfile.aspx?folder=4e2c90b2-a237-4fdf-8b77-987b2bd46392&file=LIP-8000_1.2Af.zip

Hi RR, The link to the SIP Guide is below - It also covers port fwding required on the router. Hope this helps. http://files.engineering.com/getfile.aspx?folder=926a99d2-7388-4dc6-9e9c-8ff14c4dbbc3&file=ipecs_and_sip_inet_setup_guide_v1.2.docx Regards...

Excellent James - let us know how you get on.

Hi, as curlycord as suggested - Use baud rate of 9600 on the fax machine and ensure that the codec on the SIP trks are G.711 only Don't use T38 or any complex codecs on the SIP trks. Regards Steve

Hi, I have not connected COLT SIP trks before, but they should connect the same way as Gamma, iNet, VoiceFlex, BT, etc... Is the authentication via IP Address or User Name and Password. If you let me know I can dig up my notes on setup. Regards Steve

Hi Bazza, Another option, if you run out of ideas, is to take a system database backup.. Then default the system and try swopping card positions to eliminate the KSU.. The backplane is not "dumb" and the slot may be the issue... or if you have a maintenance cabinet you could try that too. You...

Hi Rob On ISDN30 (PRI) ISDN supplementary services could be enabled at the exchange (for a cost) The iPECS ISDN line side will need to be set for this feature too. ISDN-SS CD/CR feature would need to be Call Re-routing. On ISDN2 (BRI) ISDN supplementary services could be enabled at the exchange...

Hi Eats, I have not seen that option. You can press the Speed Btn twice to take the user to the Directory. Regards Steve

Hello - the Aria IP24 (ipLDK24)would be suitable and has Auto Attendant functionality or you may wish to loo at a more up to date system like the E-LG iPECS eMG80. Regards Steve

Hi James, I have v1.2Af software - link is http://mbf.cc/j6FCs7 The link will last for 14 days. You need to read the Read Me file before upgrade, as the boot image must be installed first, then the Application file. Regards Steve

Hello, One could connect to the DTIM8 via RS232 - the from the commsnd setenv.. This allows you to change the IP Address, Gateway etc.... The easy way is to connect the DTIM8 to a router/network that has DHCP server... Then scan the network for the device IP... One you know that - you can browse...

Hello, One thing to check is the UDP Ports used by the VCIM 20000 - 20639 VOIP GW, Audio Channels - RTP/RTCP 20640 - 20895 MCIM GW, Audio Channels - RTP/RTCP Its worth checking that your have port forwarding setup to the VCIM for the above UDP ports Regards Steve

Hi Mark, I think Group Mail boxes came in at 3.9 software, may have been a late 3.8. See below on setup of grp mail boxes Must be using v3.9 Software Description Each hunt group can have own voice mail box. User can leave a message and each hunt group member can retrieve the message. This...

Hi John, PGM 233 - Auto Ring Mode Regards Steve

Hi nhlanhla, I have attached the iPECS Hotel spec to assist you. Basically with the hotel - you have Service stations and Rooms Front desk (Attd) options - Room check in/out, Maid Status, bath alarm and other hotel features. Regards...