Recent content by senibiau77

Thanks.

Hi, I have a Avaya IP500V1 Pabx running on Release 7.0 I wanted to record all calls activity made from this Pabx In the SMDR tab i have allowed the SMDR with the PC IP Adress..I am not sure for the TCP Port. Can anyone give a clue on the TCP and where can i retrieve all the data recored the...

Ok..how can I do this install direct from smdr?

What is used instead of delta server to capture data from IP Office to collect calls raw data and post it to smdr?

i have installed delta server Version5 but it cannot interface with the IP500

Hi , I am trying to install Delta Server for IP500V1 Release 7. What should be the Delta Server version

the tes824 was working and i think this fault may have been caused by power surge or from lightening..can this still be fixed..

oh i am sorry, this is TES824NZ...can anybody give a clue on this issue?

HI there, I have a new TES824 just installed few month ago with the basic default setup of 3 lines, extension card..last week port 5 went faulty..i plugged a phone directly to the port, i can hear the power tone but no dial tone. Is there any way i can bring this port back to life? Cheers

Thanks for the reply in this setup i have the same outgoing ID for Telecom PRI and Digicel BRI...so the first 4 calls picks the 4 Digicel Lines and the rest continues with the Telecom PRI The faxline are programmed also in the Telecom PRI and i cannot separate it from the PRI channels and give...

Thanks for the reply in this i have the same outgoing ID for Telecom PRI and Digicel BRI...so the first 4 calls picks the 4 Digicel Lines and the rest continues with the Telecom PRI The faxline are programmed also in the Telecom PRI and i cannot separate it from the PRI channels and give...

HI Everyone, In my setup for Avaya IP500V2 Rel 8, i have 1 x PRI cct by Telecom, 20 Channels, 2 x Vodafone Line Analog Trunk and 2 x BRI Digicel. Now, all incoming lines are programmed in the PRI includes faxlines and i wanted all outgoing to o through the Digicel BRIs first and jumps to...

Hi Everyone, I have a customer who is running on IP500V2 Rel 8. Ihe main control unit i have 2 x Combo Card, 2 x Analog exension card with BRI and PRI as daugther cards. 1 x16port trunk module 2 x 24port POTS module I wanted to install 18 IP Phones from this setup. Apart from the IP Endpoints...

HI All..Thank so much for your assistance..Have done the above and it worked perfectly...Thank you all once again!

@Telecomboy; So i remove the current working 1416 installed, reboot the system and when the system is back to normal, i plug in the other 1416 phone, is that the correct procedure?