Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by SBIDIGUDA

  1. SBIDIGUDA

    BP250 to cisco call manager ring tone

    Check CMD 1307 1308 on IP Trunks
  2. SBIDIGUDA

    IPU card in BP 250

    Change CMD 2151 to NONE after you have changed the network parameters. Bye
  3. SBIDIGUDA

    bp 250 trunk problem

    Hi,you must to unflag cmd 1307 on the trunk configuration. Bye
  4. SBIDIGUDA

    BP250 program key on operator phone to forward externall calls to a group

    Hello on the command 4001 ,set directory number of the dbc213,you need to create a key on the dbc213 with *8# (how night service activation),than on the command 1102 or 1104 (reroute at night) enter the group number.So when you active night service ,the incoming calls reroute to group number
  5. SBIDIGUDA

    BP 250 VMU-HD

    Have you load a true prompts on PCMCI?Release BP250??
  6. SBIDIGUDA

    BP250 phones ringing without any number called

    Have you a cable for CIL??
  7. SBIDIGUDA

    hi i link mxone sp7 with a elastix

    Can you post the following files? Thanks. /etc/dahdi/system.conf /etc/asterisk/chan_dahdi.conf /etc/asterisk/dahdi-channels.conf /etc/asterisk/extensions.conf
  8. SBIDIGUDA

    Hi, In a bp250 switch board nu

    What's release software have you ? R15r1a,R16r2a,R17 ecc..???
  9. SBIDIGUDA

    CATII failed!!

    Hello I have a problem when launching the command CATII, the panel does not answer me and I almost threw me out of the system and not change the time. I restart the PRH units of the CA control unit and I have not solved, can anyone help me? My system is BC11sp12
  10. SBIDIGUDA

    Absence to DBC422 and DBC 222

    Thanks!!!Perfect best regards
  11. SBIDIGUDA

    Absence to DBC422 and DBC 222

    Hi boys I can't to activate *23*X*MMGG# because dbc422 and dbc 222 tell me Proc. non eseg. Why?? Parnum??? Cat??? p.s. config file is open for DBC422
  12. SBIDIGUDA

    CIL TSE 3.2 sp3

    Hello, I have a problem with CIL on v24,because I have 2 ip extension that I'm not see calls on cil.all digital extension and analog not problem. I have a buffer on LIM 2 connect on v24 serial port,this my config: Output 1 connected. Recording enabled Type : v24...
  13. SBIDIGUDA

    CIL ON MX ONE TSE 3.2

    How do you do to configure CIL on TSE 3.2 sp2???
  14. SBIDIGUDA

    MODEM ON TSE 3.2 SP3

    Sorry I need to known how do configure modem?
  15. SBIDIGUDA

    MODEM ON TSE 3.2 SP3

    Hello I need to known how do I install a modem on ESU board??!!Somebody can help me??
See more

Part and Inventory Search

Back
Top