Recent content by phonetekkie1

Does anyone know if the FIBER XCVR 300A SM is ST or SC? I can't find any pictures of it

When I call the pilot # it rings 4 times and says "that ext doesn't answer". If I call an extension it makes me put the ext in again when it covers. I can leave messages after I enter the xt again. I can also retrieve messages. What am I missing

Does anyone have a doc or send information on how to hookup the analog portion of the Intuity LX. I have the CLAN integration working but I don't know how to hook up the analog boards. How are the stations pinned out to the inutity from the analog board?

I'm doing video over TN556B with a Polycom. My out bound works great. I have 3 DID's for my 3 channels off of the 556B. When I try to dial to the camera I can't sync up. How can I make one number pull all three channels. Can I pull another DID to mesh all three DID channels? Any help would...

The sites are connected via point to point T1 and DS1. So if I have IPSI's in the EPN the remote EPN will stay connected to the S8500 in ESS? I'm assume the TDM calls will drop on the remote EPN's when ESS takes over

I have a site that I will ESS off of a main site. I have two sites P2P off of the ESS as remote EPN's. If the connection to the main server goes down and the site goes into ESS will the EPN's stay up? I believe they will but I'm looking or the warm and fuzzy. Anyone doing this?

thanks I have the TN570 not a TN571(typo. I just wanted make sure I'm not missing anything. Thanks again

There is a product called Mutare that can send emails with Octel. We use it, not a bad product. Good for remote users www.mutare.com

I just want to verify that all I need to EPN a G650 off a MCC is a TN573 and a TN571. The two building will have single mode fiber. Does anyone know the part that connects the fiber? DO I need any other boards in the G650 or MCC. I only going to have 3 analog boards in the G650, no phones...

phoneguy55 you've been a big help so far Let me make sure I understand The Blue pair go to pins 4 and 5? Which pins does the white blue go to and which does the Blue white go to? The same for the orange pair. I using this on a VSX3000 with the 4 port BRI built into the unit. Do you know...

sorry for the extra question but I can't get the video unit to come up. The BRI light on the VSX3000 doesn't light up and the BRI stays down on the camera. I have Polycom and Avaya onsite trying to figure it out. I figure I'd come back to the experts on Tek-Tips I have the BRI board installed...

Thanks again for your help

phoneguy thanks for the info, I got around this error Did you setup a bri-board (add bri-trunk-board 01b11) ?

Is the Port: 01B0201 your BRI board? I get "01b1101" May not mix BRI stations and trunks on one board; please select another

can you print out your config to your TN556? Also, how did you punch down the wire to the units. I used the following on one port WB WB BW BW WO WG OW GW Any help would be apprec