Recent content by penroy

Currently I have an operator group configured on my NBX system. This is to ensure that all call are answered once the operator is busy. The other user are complaining that the operator is not doing her job because all call are being routed to their extensions. I checked and found once the...

I have a 3com NBX100, I have noticed for the pass couple of weeks users are being disconnected from the system. This seems to happen in the afternoon at about 12 noon. When I connect the system to my laptop it works, when I dial into the system all is well, I have checked to see if there is any...

gwebster, How do I get it connected to the BCM to get the full software. I have been trying without much success.

That is the configuration I current have, but its not working as it should. The phone are configure on VLAN and I have specified the same in the BCM but the phones just say starting dhcp.

I have some new AVAYA I1210 phone to con figure for a BCM450 but I am unable to get into the configuration to setup the phones. From what I am seeing it seems the firmware are different is there a way to down-grade the firmware.

I have a BCM 450 and I would like to configure the system so that once a IP phone is connected to the network the configuration is automatically deployed to the set. The phones I have are i1210.

I have a BCM450 with GATM8 module configured with 6 lines. The card has gone defective two times and it happened after ran was falling and thunder storm. I am now doing some research to see why this could happened. One possible clue is grounding, but I have not seing any independent gounding on...

Oldestgeek, thanks for the input I will try your suggestion,however pardon my ignorance but what is a SAP.

I have tried your suggestion oldestgeek and we were able to see the status of the user.

Yes, I assigned it in the programing.I will try your suggestion Oldestgeek and let you know how it goes.

I have a T7213+KIM connected to a BCM 200 rls 4. Currently on the KIM the extension within the office configured.The problem we are having is that when the users are on their extension the status does not show on the KIM.However if u press the extension Keys on the KIM it dials the extension...

Is there a way to reset the password on BCM 3.7

I have a new BCM50 which I am unable and I am unable to login. I trying to do a level 1 reset but it does not seems to be working. The power light is set to green and the status light is set to red.

snowman, I have connected the trunks, but no look. The status light on the card flashes between green and amber.

Telco, I did what you suggested,however I am still having a problem.