Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by OlegPowerC

  1. OlegPowerC

    SMGR 8.1 The Web Server X509 certificate is expired

    Dear freinds System manager 8.1 show in web gui "The Web Server X509 certificate is expired" I have cli access to this server. In version 6.3 I used CertificateRenewalUtility_v2.bin But I think in 8.1 have any method for renewval certs. What I need to do? Thank in advance.
  2. OlegPowerC

    Avaya IP DECT Master and Standby Master and trunk to CM

    Hi collegues. I am complete task: After master is down (I am disable PoE to it), standby master goes to active. Then after 3-5 minutes, I check trunk group to this master (status trunk 2) and see Out Of Service In my XMOBILE stations, field Mobility trunk group was 2 and after trunk 2 goes down...
  3. OlegPowerC

    Avaya IP DECT Master and Standby Master and trunk to CM

    Hello! Can You explain me next: I configured 18 DECT stations, one of this is Master and one Standby Master. I configured H.323 trunk to Master and H.323 trunk to Standby Master But in XMOBILE station I provide one mobility trunk group. How I can do redundancy? Thank You!!!
  4. OlegPowerC

    Avaya IP DECT phone status (connected or not)

    Hi. I make application which connect to CM and SM and get phone status. H323 and SIP show as connected if this phones realy register on CM/SM But I also want to know status of the DECT phones. I can check subscribed/unsubscribed but can I get information about phone state (on/off)? Application...
  5. OlegPowerC

    h.323 trunk Avaya CM-Avaya CM Unicode names

    Thank You but it is about station. Station to station work OK (show Unicode names) but Station->Trunk->Station not good
  6. OlegPowerC

    h.323 trunk Avaya CM-Avaya CM Unicode names

    Hi. What I must do for CAM show localized name if I call from CM 8 to CM 6 though H.323 trunk? Thank You!
  7. OlegPowerC

    Cross talk issue on sip inbound calls from Verizon carrier

    Ok. I think it is because media RTP packet going to same port. Can You do packet capture? I want to see SIP+RTP from Verizon to SBC
  8. OlegPowerC

    Cross talk issue on sip inbound calls from Verizon carrier

    Do You use avaya Session Border Controller?
  9. OlegPowerC

    No Dial Tone or Dialing over VPN

    Hi, I also use many ASA and Avaya phones but no problem. 1. Please provide to us crypto map ACL and filter 2. IP address of your phone 3. IP address your CM and G450/430 or other media gateway
  10. OlegPowerC

    LDAP connection with SMGR

    When You install AADS - You can configure LDAP do You do this or skip?
  11. OlegPowerC

    Session Manager PPM and dialplan

    Thank You very mutch! I change 3xx -> AAR to EXT and add in UDP 3xx->AAR and now in PPM i see next: <item>#xx</item> │ <item>2xx</item>...
  12. OlegPowerC

    Session Manager PPM and dialplan

    Thank You very mutch! Can I modify this: In dialplan i have: In the aar analisys: PPM generate: 300+ and 8Z300 Why 300+? in dialplan i have minimum and maximum 3 H.323 phone work as expected
  13. OlegPowerC

    Session Manager PPM and dialplan

    Hi!. My SIP ext is 208 and H.323 ext is 250 and Cisco phone behind CUCM is 700 When I call 250 - phone 250 ringing immediately, but all other whait interdigit timeout (or I can press #). It is may be because SIP phone can not get dialplan by PPM. I trace ppm and not see any getDialPlan requests...

Part and Inventory Search

Back
Top