Recent content by NickStroud

Thanks Mark, suspected that was the case, thanks for confirming.

Hi all Finding it difficult to get concrete plans about the planning ISDN/PSTN switchoff process, has anyone else found out info about this? The latest I have heard is the following from one telecoms provider ("They"): They now have further information about the timing and process for...

Hi Im considering adding DDI numbers to our Panasonic KXTDA30. Do I just order a group of DDI numbers to add to one of our incoming CO lines and then direct those numbers to their appropriate internal extension using the DDI table, or is it more complicated than that? Our incoming lines are all...

I am advised that only Panasonic certified engineers are able to install the NS700 - is that correct - I am told that only certified engineers have access codes for the system setup and coumentation. Could you please clarify this point? I have instaled several other PBX's inc our current...

Hi I'm investigating SIP trunks for our business in order to get ready for the great PSTN/ISDN shutdown. We have a KX-TDA30 PBX. Do I just need to get a SIP trunk card such as the 4 channel KX-TDA3450 card then then find a SIP trunk provider to link to and configure the SIP trunks as the CO in...

Hi We have a virtual office number in Ireland which is forwarded to our KD-TDA30 in the UK. Is there any way to get a different ringtone in the UK if someone calls our Irish number or disaply the caller ID on our KX-T7630 phones so that we know the call has been made to our Irish virtual number?

Hi One of our lines is a split fax line, one libe going to our fax machine and another going to a CO port on the phone swicth to enable us to have an extra outgoing line when the fax is not in use. I would like to disable the incoming call tone so the phone extensions dont ring before the fax...

The extra MEC and power supply worked thanks for your help everyone

Dont worry, found reference to it6 in the programming manual

Is it KX-TDA3105X?

Ive looked in the manual and there is no mention of a memory expansion card for the TDA-30 and I can only find these available for TDA-100 up....the TDA-30 seems to use an SD card for memory, where does the MEC plug into, and do you know the model number?

Great thanks, based on that formula I get exactly 28 when I run into problems, will get a MEC and revert back :) Thanks for your help

I have the original PSU in DC1 and the secondary PSU in DC2

Hi Otoni - yes it is....

Hi, I have 2 DC adaptors plugged into DC 1 and DC2