Recent content by n299876

Will go to site and try, thanks!

Hello all, I have a Startalk 1.7 with 8X24 dr5 installed, and for some reason I cant get the startalk to answer lines 1 and 2. It will answer 3-6 no problem. I have checked the tables, the line settings, business status,....strange! Any help would be appreciated!

Curly and Rik! Thanks for your replys, I have tried everything, I agree it does sound like a CO issue, however, Bell Canada has investigated thier end and says it is not a co problem (surprise surprise) NETWET, Not sure what your eluding to but Fwd no answer?? Light Bulb?? "in the head...

Let me re-phrase You are are on a call (on any one line 1-8) another call rings in The display says incomming call (as it always does, because this programmed as a ringing set) A mysterious womens voice, interupts my current call and says " incoming call" then I am connected to my original...

the call does not disconnect

It is not line specific ,happens on lines 1-8 I just used line 1 as an example..

Hello all! I have a CICS installed (4.0) 8 sets and 8 lines, and for a couple of years now, every once in a while while my client is on the phone thier conversation was cut off by “Incoming Call”. It displayed INCOMING CALL on thier display and then Line #2 rang into the office.. Anyone ever...

I have a company that had 1 base unit with 3 handsets on it. They then after a while added the 4th handset... All is good... They then needed more and I went in and added another base unit with 3 more handsets... I did some fine tuning and needed to allocate some space between base units. So...

Hello! I have 2 CICs (6.1) installed in a medical building, and I have been having a tough time with volume issues on their system. When they call out they have a hard time hearing the client, and the client has a hard time hearing them. I have exhausted my knowledge, adjusting set volumes...

Dasheen, Yes I have all the uptto date patches done, and the alarms are 41,42,367,44,75, and there is only one led on PRI card, bottom left.

Hello all! I have a BCM 400 4.0 installed, with approx 10 digital sets, and 20 IP on a PRI, At least once a week, this switch seems to go down, the main reception console (T7316) starts to flash, and comes back with an error. alarms I see are 41,42,367,44,75 The telco did a remote test and...

When I do a manual 611 you hear nothing, If I select page zone 0, and page F610 then it works. I need to have diffent zones, ie sales, marketing, and I cannot select 1,2,3 etc.. within page zone in capabilities for any set.....weird...first time I have seen this, I might do a Start-up as the S/W...

I have just installed a MICS 7.1, and in capabilities, I cannot select any zone except for 0. If I enter 1,2 3, they do not appear, any suggestions?

Does anyone have a step by step guide on how to implement this feature. My customer bought 8 seats for thier BCM 50 and I have never installed this before.

Anyone know what class of service I can assign so the users passwords never expire? (some people hate changing thier pass words every 30-90 days)