Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mselby83

  1. mselby83

    SPE down can't access

    Thank you.
  2. mselby83

    SPE down can't access

    I kept getting STO-DATA alarms, I was able to clear them but the alarms kept coming back. This is a duplicated system, the problem is on SPE A. I powered down SPE A (CARRIER) installed the new TN2211 put the disk from SPE B in, powered back up.I couldn't do any commands because I kept getting...
  3. mselby83

    SPE down can't access

    I replaced a TN2211 optic drive on the standby-spe, now when I status SPE I get a not functional also I have no shadowing or handshake, I can't perform any troubleshooting because I can't access standby spe. This is AVAYA g3r v10. any thoughts
  4. mselby83

    Replacing a TN 2211 OPTICAL DRIVE

    Thank all of you for your help. I performed a save translation, backup disk both full and a test storage data and the alarms cleared.Hopefully they wont come back. Thanks again
  5. mselby83

    Mitel 2000 PRI to H323 Gateway

    I have a Mitel 2000 PRI that's connect to ATM. I'm in the process of moving the PRI from the ATM to a H323 Gateway. Do I have to log into the PRI to make changes or should the Cofigurations remain the same. Thanks
  6. mselby83

    Replacing a TN 2211 OPTICAL DRIVE

    I have a G3R v10. I keeo getting STO-Data minor alarms,I am able to clear the alarms but within 48 hours the alarms return. Id like to replace the TN2211 with a new TN 2211, does anyone know the process of this, Thanks
  7. mselby83

    ARS/AAR/ capacity

    Hello, Does anyone know the difference bettween ARS/AAR capacity and the percentage I see up in the Right corner when I do the command ch ars a 5. I have a G3R and their is a difference but when I do a disp sys capacity and it gives me a used, avaiable, system limit.Thanks
  8. mselby83

    incoming call handeling treatment

    I'm using v9 I only have 3 pages, I'll try using the AAR code, I'll let you know if I have problems, thank you for your help
  9. mselby83

    incoming call handeling treatment

    No,if the numbers resembled each other it would make this much easier, here is a example, I can't cut and paste, I work for the Dept of Defense but here is a example. len min max del other 10 7035672345 10 10 10 8506 ext
  10. mselby83

    incoming call handeling treatment

    I have a PRI trunk group with 23 DS0's. When a call comes in to this trunk group the incoming call handeling treatment routes the call to the appropiate station. I have a G3R, I need to route 200 numers but the trunk group programming only reserves 3 pages for this and digit conversion does not...
  11. mselby83

    Intergration problem with Avaya G3R and a Octel 250

    I have a Octel that is offsite and works great with Mitels and Harris PBX's. My problem is I'm trying to get my Avaya to work correctly. When I call a Avaya phone it keeps forwarding to the "open trees" recording, I need it to forward to the actual mailbox of the phone I'm calling.

Part and Inventory Search

Back
Top