Recent content by mpedersen

thanks for your help. This is an E1 from France Telecom. If this is a layer 2 issue the circuit is cabled properly, correct? Can the issue be caused by misconfiguration on the router or something on the network's side? I am asking because I see the following: Transmitter is sending remote...

I also get the following sspariaovip01#show controllers e1 1/1 E1 1/1 is down. Applique type is Channelized E1 - balanced Transmitter is sending remote alarm. Receiver has loss of frame. alarm-trigger is not set Version info Firmware: 20030723, FPGA: 255 Framing is CRC4, Line Code...

Many thanks for the reply. Yes this is going to the PSTN in France. Im wondering if I have the right module on it for E1 for voice. Do you know if I need a specific module for voice? right now I have an E1 Module that came on the router. Also the E1 is cabled to an RJ45. The CD light not the...

Serial1/1:15 is down, line protocol is down Hardware is DSX1 MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation HDLC, loopback not set Last input never, output never, output hang never Last clearing of "show interface"...

Hi there, I am looking for some help on getting an E1 ISDN PRI up and running. This PRI will be used to communicate with Call Manager. My relevant running config for a Cisco 2650 1XM with a WIC module on slot 1 is below #show version Cisco IOS Software, C2600 Software (C2600-IPVOICE-M)...