Recent content by mevans1974

Hi I have a 3300ICP rel.9.0. The system has 2 embedded T1 module we have 2 PRI connected to the system 1 of the PRI is working and the is not. I know a reboot will fix the problem but I can't reboot the system in the middle for the day. I need to know if there is a command that I can use to...

The core switch is cisco 4500 series L3 Do you have the command to setup trunking on the nortel switch..

Hi We have a 1200 IP phone on a BCM with Nortel 4526T-PW switch the problem is we can't get the switch to work correctly The customer has 2 Vlan on their network Vlan1 Data Vlan 3 Voice all the phone that is plug into the core switch is working with no problem any phone that is plug into the...

Thanks Dasheen that corrected the problem..

This is a New Install all phones will be IP sets. Yes I have the CEC card install. if am facing the BCM it is installed in far right slot. It will not let me Increase the Numbering plan for the IP set. I try and I get this error "Invalid Starting DN 0r Insufficient Free DN'S Remaining

Hi I Have a BCM 450 and we are installing 110 IP phones on the problem that I am having is am only able to install 46 IP phones. We have keycode for 110 ip phones but when I go in telephone resources it show that my DN for my IP phone are from 2100-2147 When I try to configure IP sets from...

Thank you that work like a dream..... Once I put the option in the DHCP all my phones came up.

Hi We are install 1200 series phone on a BCM 450 but we are unable to get them to work. We have 2 Vlan on our network Vlan 1 Data and Vlan 3 Voice. I know with the 1100 series phone you can tell the phone what vlan is voice and what vlan is data I made a test with a 1140E phone and it work...

I have the user added under the CDR group.

BCM.R400.SU.Desktop.016-20100 BCM.R400.SU.System.026-201002

Hi, I have a BCM 4.0(4.0.2.03) software we had the CDR push working for a couple of years until load some patches to the BCM then it stop form working. We are using a calling accounting system for www.callaccounting.ws I know the calling is working because I was able to collect the data for...

Thanks for all your help I found the problem. I had to load a patch on the BCM 400.

yes.. when I dial 7 plus the extension I can see in the BCM monitor that I have access to the VOIP trunks I also see it on the display. But what I have notice on the BCM 50 I have to BlocA, BlocB or BlocC etc but on the BCM 400 I can not use a Bloc all I can use is Pool A,B,C,D ect... I don't...

I have access to both of them I'm using Softphone on the farend BCM50. and using Element Manager to program both of them. We have a VPN connection between the 2 sites.

I have the Licenses for both system 2 SIP GW license Each system have 2 License