Recent content by matthias7

Hi i like in some way see how much time each en every DTE have been up and connected to my cisco 1811 router since we have installed some new equipment and do not know their ip nor exactly where hey are connected and to what interface at this moment. matt

Hi I have an Mikrotik RB750G and i think sucessfully configured the IP for port 1 but the VPN configuration i have configured from Mikrotiks webpage video seems incomplete since i do not define remote Routers IP for the VPN that makes me start thinking something new for this router or ? ...

Hi I am entering in from the ethernet interface on the router that have the serial x/x/x:0 that i can reach at all time and then from that router an leased T1 line to the other router that i can reach and log in for 2 minutes and then went down and comes up again and goes down ... today the...

Hi This is he output from show interface serial x/x/x:0 when no connction with client cisco router ******************************************** Serialx/x/x:0 is down, line protocol is down Hardware is xxxxx Serial Internet address is xxx.xxx.xxx.xxx/30 MTU 1500 bytes, BW 1536 Kbit, DLY...

Hi More data that i got and forget to mention ... The cisco router with serial interface x/x/x:0 says when other cisco router on the other side of the T1 line is not responding that serialx/x/x:0 is down and line protocol is down and when remote router resons it says that serialx/x/x:0 is up...

Hi We have an T1 leased line between 2 routers, let me tell you from the start i am no Cisco Expert but an happy new bee wanting to find out why it is happening and what is the main cause, i am familiar with cisco and commands. The client is complain it that the internet slows down in the...

Hi I hope this is the right forum for this kind of question otherwise i apology for inconvenience. We have an Netgear FSM7328S installed in the Computer room and at an Customer premises an Linksys E2000 router and i like to monitor via SNMP if possible and "traffic shape" their data usage...

Hi Thanks for your input, time will tell if bad port in PBX is the one to blame or not. Tried with other old phone with same result so i think as well the port is bad but who knows for sure. Matt

Hi I have an client that have an MICS old version and now one extension get unusable but after unplugging the phone and plug it in again it acts normal for a while but now the error is appearing like every 2-3 days. Change Extension or is the phone to blame, i have changes phones but appears...

Hi this is the best way to configure sending of data when something happens ... config terminal loggin time ... local time logging trap warning logging xxx.xxx.xxx.xxx(Server to send loggs to ) logging on end matthias

Hi Is severity warning good enough and facility is local 7 or how do i know ... matt

Loggs from after an crash or reboot todyay oct. 27... router#show version Cisco Internetwork Operating System Software IOS (tm) 3600 Software (C3640-JK9O3S-M), Version 12.2(19a), RELEASE SOFTWARE (fc2) Copyright (c) 1986-2003 by cisco Systems, Inc. Compiled Mon 29-Sep-03 23:45 by pwade Image...

router1234#show environment all Power Supply: Redundant Power System is not present. Board Temperature: normal. matt

router 1234#show logging Syslog logging: enabled (0 messages dropped, 0 messages rate-limited, 0 flushes, 0 overruns) Console logging: level debugging, 28 messages logged Monitor logging: level debugging, 0 messages logged Buffer logging: level debugging, 28 messages logged...

Hi I read threw the Cisco about traps and well makes me more confused ... What do i suppose to look for or what should it send to me when it goes down ... The Cisco documentation tells me that not always is vise to use traps since maybe ant an crash it might not be able to send any usefull...