Recent content by markk85

Thanks that works fine.

I have hidden database window on startup of my databse. I now want a button on a form that I can press to show the database window. Doe anyone know what VBA code I need to write for that button to show the database window? Thanks

I have a table called User with the fields: Name Option I want to create a report that will show a list of the names in the table that have selected the option Tennis. I have started on the code but am a bit stuck as to where to go next: Dim db As Database Dim copyofselections As...

The motherboard hasn't got native graphics so I can't try that. I can't install the graphics drivers in safe mode as it says I need to install .net 2.0 framework and I can't seem to install this in safe mode. I have also disabled automatic restart. This seems to make no difference as the...

Also I have tried a memory test and it reported that there were no errors found.

Yeah I can get into safe mode and that runs completely fine; it never crashes at all. It's just when I boot into windows normally that it crashes.

I have recently changed the motherboard on my computer. I was running windows vista and it kept crashing. Sometimes the screen would flash on and off saying that the display driver had malfunctioned. I tried updating but this didn't work. I therefore decided to try a clean install of windows xp...

I tried Nlite and that didn't seem to work. I have found the drivers on the motherboard disk. I put them onto a floppy and pressed F6 to load them on set up. It detects the file as VIA VT8237 Sata Raid Controller. However, when I press enter to install this error message comes up: "File...

I am trying to install windows xp on my computer. I have Asus k8v-x se motherboard and a maxtor 200gb sata hard drive. The hard drive is detected by the motherboard but when I boot from the windows xp install disk it says: "Setup did not find any hard disk drives installed in your computer"...

Sorry I wasn't clear. Pressing F8 while the computer boots up does nothing at all - I get no options so can't try last known config. There is no vista boot disk on the site above. Is there anywhere else I could get one from?

I have just installed vista on my pc. All was fine until I installed the graphics drivers for my 256mb ati 9800xt. I rebooted the computer and the following message comes up: Booting 'Windows Vista' acpi Vista Loader 2.12 Done! fallback 1 find -- set - root /bootmgr It stays on this message...

Just thought I would let you know that I finally fixed it. Tried a new psu and cpu, but in the end a new motherboard fixed it. Thanks for all your help!

Ok so i've just tried a new motherboard battery and it's not that causing the problem. Can anyone help? Does it look like the cpu based on the above pic?? Thanks

I have reset the cmos and the psu - still no joy. I have also cleaned the cpu and heatsink and put on new thermal compound. I doubt that it is the bios as the mb has a dual bios and it was powering on for a few seconds previously. Could it be a dead mb battery? - would this cause it not to...

So if I just had a motherboard and psu connected (no cpu) - the computer should not power on? Is that correct?