Recent content by krasemir

This what i`ve : 4653782227 ENTRY 0 HNTN ESA_HLCL ESA_INHN NO ESA_APDN YES HLCL DIDN YES HLOC LSC CLASS_FMT DN ENTRY 1 HNTN ESA_HLCL ESA_INHN YES ESA_APDN YES HLCL DIDN NO HLOC 465378 LSC CLASS_FMT DN CLASS_FMT DN7777 TN 100 0 00 01 VIRTUAL...

Hi All how can I denay the extension DN to be apear afte CLID ?? the DIDN is set to No

SO, no need to replace the CPPM?(as in rls 6 the cppm & ss now in one card |) , and what the CLI ?can we proceed using it or we must use UCM ?? And if you please tell me what more feature or benefit it will be more than on rls 5.5 ??

HI ALL Having cs1000e rls 5.5 HA , what we need to upgrade to rls 6

but as I see the document is for CS1000 v6.0, Phase 2, and my system is rls 5.5 ???

thenks John , could you please point to the document or NTP that can I used to install it ??

does the cs1000e rls 5 or 5.5 support sip phone type 1535 ??

it is write the new loadware, and when i print iss , i saw the new one , and as i said now it go back to the default . did the way that i used ( via EM ) is correct to install the loadware ? do i have to install them twice for the 2 CPPM ? and how ??

As we know in HA system ,one CPPM is Active , the other is in stand by mode , what if there is power cut on the MG in wich stand the active cppm , is it write the other cppm must automaticaly handle the PABX JOB ??? Regarding the "upgraded " : While the system is running , via EM I`ve...

7 months ago , we installed CS1000E rls 5.0 ,I`ve done the upgrade for the loadware and installed the deplist , Last week while we tested the CPPM redundancy , I`ve rebooted the first CPPM witch was active , suddenly the second one also reboot ,all phones was down , and the strange thing all...

Yes, it is a node pass., thanks to all of you for the replay

I`ve installed many Pabx , i`ve never seen 2002p2 or 2004p2 requiered a password to install it !! could you please tell me what is the pass. ???

I`ve Already programmed 2 IP phone 1240 and 1230 and they work fine, Node =1, TN is programmed. the problem that the telephone don’t asked about the TN as usual telephone programming , a it aske about NODE ,after that it ask about password, I don’t know which password it need ?? Then the...

The phone I try to install is 2002p2 and 2004p2 . what is tis INVALID TN 000.00.00.00. Super Loop that Iuse is 4 0.

I am having issues redirecting IP sets from my CS1000E RLS 5.5 , When trying to configure new IP phone ( any type ) I’ve got the following : Node id -- Password -- I don’t know what password is required, then Invalid TN 000.00.00.00 Reason un equipped Already I have 2 IP phone programmed...