Recent content by JCO08

I have the following messages: Unacceptable QoS packet loss: (2.2)% in zone (8) mfc008 12 SRPT181 XSM: Alarm signal detected- check the power / fan module XSM SRPT183 XSM:Alarm signal cleared

I would appreciate your valuable help, I have a problem in the cs1000, the problem is intermittent, the audio goes away during the call.

I need to delete 2353567 like COT because i need to program 2353567 like analog line Ld 21 REQ: ltm CUST 0 ROUT 73 TYPE TLST TKTP PAG ROUT 73 DES Bldg.14 TN 056 0 00 06 MBER 1 Bldg.14 >ld 21 PT1000 REQ: prt TYPE: rdb CUST 0 ROUT 73 TYPE RDB CUST 00 ROUT 73 DES Bldg 14 TKTP PAG...

Thanks KCFLHRC,[smile]

When I remove 84 0 14 0 / 3 cs1000m send this error MEM303 Memory management: Top of block freed - probable leak blockptr: 754BB72, block size: 6, freed size: 5, page: 5, remaining block: 754BB77

Thanks , it works!!!!! [smile]

Thanks KCFLHRC, In which ld I print the mfc to see how it is programmed, I went to ld 20 I did prt 84 0 14; Do I just need to go to ld 13 and do new, mfc and TN?

The loop 84 of the cs1000m does not pass the test of ld 30, it disables the cards; we pass the digital lines to other loops; in that loop we have an MFC card in 84 0 14, when calls were made by the dti2 trunks there was a delay we did not ring back, disable the card 84 0 14 and we do not have...

We have a cs1000m with tty problems. The paddle board has a red light on. When I do LD37 stat tty all are enabled but there is no communication from the remote sites and locally I can not communicate with the CPU.

I need to make a report of the serial number of each phone on the pbx, without using the command line (ld 32 idu), I'm looking at the help menu on avaya aura system manager without results. thanks

Cls rngi

How can we do for 1150E to ring two times? Thanks

When you program the IPPhone 1150, in AST you must type the number of keys you want to be controled by the symposium, for example key o acd 374xxxx o 374XYXY key 3 scr 374YXYX in this case AST must be AST 00 03 Remember the phantom is another DN , 374XZXZ with FTR CFW 7 Sorry for my grammar

When the agent log into the phone 1150, the personal dn doesn´t appear , we create a phantom dn with ftr cfw 7. Thank you for your help.

thank you very much, it works! i was typing 244-00-13-05 but i must type 244-0-13-5 and this one works.