Recent content by hartburn

Of course - every user's favourite key! I will test that and make sure having to press a shift key and one other isn't a step too far for the users. Not to mention having to disable Make Set Busy after a call. But there is always that lovely tone as a reminder. Thanks for the help.

I thought about that, but the set is for two people using it at different times. They need different DN's as they cannot share a mailbox for messages. They both need an audible tone if their line is idle, but when busy they need the other to be silent, or at least only give one ring/buzz. TN's...

Hello bigindian65. If set to buzz, does this not make it buzz for the duration of the ringing cycle? That is what is happening now when the active call is on the handset. If the call is on speaker, the incoming call to the other line buzzes once. We want it to either stay silent or buzz only...

Hello On an Opt 61C 2511, we need a 3903 set with two different DN's, each on an SCR key. Is there a way of having only a visual indicator of an incoming call on one line when the other line is busy on a call? For some reason, if the original call is on speaker, the other line only buzzes...

That simple, but I never would have looked there! They like me again now, at least for today. Thanks for the swift reply.

We have 3900 series sets which do not show cpnd of the originating caller when call pickup is used - it shows the name of the called set instead. Picking up a call on 2616 sets shows the original caller's name. Any idea why the 3903's and 3904's only show the called name instead of the...

I could be well off the mark, but are the ANUM values different for the two consoles? The one you have posted is 01, the other should be 02. Our is anyway.

Fianlly got the telco to swap the card in their exchange and everything has been stable since (fingers crossed). Thanks again for the advice.

OK, I will take it up again with the telco. trvlr1 - thanks. I outed the phone then reinstated a copy on the TN. All ok there as a result. Now just waiting to see which TN's have locked out this morning after grabbing those two bad channels. If I get any insights from the telco i will put...

I have looked in related threads but cannot see anything which explains or resolves this issue for me. Opt. 61C We have two PRI channels which keep locking out - always the same two channels (24 & 26). If re-enabled, they lockout almost immediately. The channels never enable automatically. We...

Loop 06 is our current EuroISDN. I think this was previously on Loop 20 but maintenance changed it to 06. Loop 24 was previously (now unused) a 2meg tie to an opt 11 at another site. I assume the card for this is still in there. This should also be duplicated with a similar unused setup, as...

He he - your advice just gets better and better!

No E1's as far as I am aware. Here is the cequ: CEQU MPED 8D TERM REMO TERD REMD TERQ REMQ SUPL 008 012 N136 SUPC SUPF DDCS 004 005 DTCS XCT 002 018 TDS * 002 * 018 CONF * 003 * 019 MFSD * 002 * 018 PRI2 006 020 024 APVL DTI2 MISP...

Looks like DISA is the way to go. I will look into it - convincing the powers that be should be interesting. Thanks to all for the advice.

Hello I have looked around a fair bit but, due to ignorance in this area I cannot honestly decipher what I need to know. Here is the issue. A vendor has offered to lend us an Asterisk for a limited VoIP project, for the time being within the same site. Our IT people are keen to give it a go...