Recent content by gameoflife

anyone any ideas why fmprog cannot see a flash card, i have card wizard as well and this has the same issue. i think this has happended before but i cannot remember what i did to fix it thanks in anticipation

can anyone tell me what feature set i will get with the qsig connection on a hipath 4000 v2 thanks

bang on..... it was the npl i have used a different range and managed 100 so far... the rest are going to be a slog !! thanks

don't ask re speed dials !!!!!!! its just something they want (security apparently) i get FROM PRIV_LIB#- 7000 (first Priv.Lib.) TO PRIV_LIB#- 7039 (last Priv.Lib) even though i have allocated 200 !! volume... complaining the volume is too low,maybe it is the gain as it is...

couple of questions i have been to by bs-support that the contrast on the 207 and 208 ip phones cannot be changed but i though i read somewhere it could .....any ideas ? can the volumes be set on a per phone basis ? i have set 3000 priv libs in siz and want to allocate 200 each to some...

can anyone tell me the codes for forwarding calls from the basic and display handsets on a bcm 50 thanks

Thanks for that the other big problem is that when the phone relocates it disconnects from the network , so if your pc is plugged into your phone that loses connection for a short tome as well. this means that you could only relocate first thing in the morning maybe.

good call but there are 60 users..customer wants them to login each time maybe acd is the answer but they want their own ddi and mailbox basically they want hot desk but on the cheap.

has anyone used this feature ? it seems to work absolutley fine with digital stations, but when you use it for ip phones it takes up to 50 seconds to register. does anyone know if this is correct or should it be just as quick as a digital phone ?

i have now used cvd pro it appears much easier and quicker than i was told also adding feature auth is extremely quick

does anyone know how to upload the feature auth on the cvd pro... it asks for a .om8 extension but when they are sent it is a .ex.n ????????????????????????????????????????????????????????????

does anyone know why i have to drop the leading 0 when dialling out on the coral ipx office

brilliant thanks

i have programmed a different zone for the sip vmail ports remotely and have been told you have to reboot for this to action properly !!

Apart from the obvious switch is there any way in the software to reset the coral