Recent content by FYRGUY

Thanks to everyone. Until next time... Chris

Thanks Skip. Chris

Thanks Skip. Can you shed any light on the ";;" after General in my last post? Chris

Tony, The "General;;" worked perfect, Thank you. Could you briefly explain the ";;" behind General. I wasn't even aware of something like that. I assume there are other special symbols that do things. Is there a good book or a place I could reference these. Thanks again Chris

Sorry it took so long for my reply back to everyone. I will give these suggestions a try. Thank you very much Chris

Greetings, In MS Excel, in a single worksheet, I am trying to sum cells F17 & O21 and put the answer in cell O22. I have a certian critera that follows. I have tried =IF and =SUMIF and can't seem to figure it out. Probably simple but I am out of attempts. Here is what I am trying to do spelled...

Sorry, & thanks

Greetings, I am using MS Excel. In a single worksheet, I am trying to sum cells F17 & O21 and put the answer in cell O22. I have a certian critera that follows. I have tried =IF and =SUMIF and can't seem to figure it out. Probably simple but I am out of attempts. Here is what I am trying to...

Thank you CarlAK. I am not sure on the "adac.lsp"? I will check with an IT guy here at work and see if he can help me do that. Thank you Chris

Just a thought... Under the object manager docker, re-arrange the order to your liking. This may not be the absolute fix, however, can be very effective to minimize travel on the laser head. The laser will vector in the order from top to bottom on the list. Hope this helps... Chris

OK, I thought that fixed the fill, but it didn't. It still will not make it the default when I open a new page. Any ideas?? Chris

Thanks CarlAK!! I entered it in the command line, then realized that it meant "Hatch Pattern Name".. Entered "solid"... boom done. Thanks!!!! Chris

Thank you for the reply, I do not know exactly what you mean? I am assuming that I enter that at the command line at some point? Could you please explain just a little more? Thanks Chris

I am using AutoCAD LT 2005, I am setting my defaults under the "aclt" template file (which is the default page I have set to open new drawings). I have set several items, however can't seem to set the default fill to solid. Can I do that?, and if so, could someone go through step by step on...

Hello everyone, I have a file (P.A.)in a folder (Dept Forms) on a server at my work. This form,an excel file, is used by all employees accessed by a common server. When "I" open the file it is a "read only" file. Only the creator of the form can edit it under the same name, I can edit it but...