Recent content by ForumUser01

I concur with 'imbadatthis'. After removing 'established' keyword, what IP you are trying to reach? 192.168.x.x is non routable on internet. Do you have static 'nat' configured on the router for this server? If so, allow the ACL to access public IP. Hth MS

I tried to mark this thread answred/star but not working. How to rate the post? Thanks MS

Great.. That worked like charm. I guess I can also remove the ext as they are no longer used. Will that work as well or 'X' is the only way? Thanks again MS

Thank you both. Majrity of the boards are empty (Port usage -None) but couple of boards with 1-2 extensions that are not being used. Can I just 'busyout' the extension/station and remove the board? Thank you MS

Hello Experts, We have Avaya G650 /8700 running Definity R013x.01.2.632.1. The system got few unused TN2224 (Digital line-24 Port, 2 wire) and I want to remove the boards from the system to bring down the support costs. Searching in this wonderful forum, I found very helpful thread...

Hello, Main site 2 x8700 with #3 650 Gateways (Definity 3.x). DR site ESS -8500 with couple of gateways. Due to building power related work, we need to shutdown the mainsite gear (after the UPS runs out). Not planning for failover to DR site or anything. What is the recomended sequence of...

Thanks Wilson. Infact I was using wrong code sequence to get associated with PBX. All set now. Thanks.

Hello Gurus, Need help with SS2 installation on Avaya Definity 3.x. When I connected the unit to a analog port (connected to PBX) successsful in getting the dial tone but unable to make internal calls (4 digit ext) or not sure what ext the unit is getting. The port on ASA still showing 'X'...

Hello Gurus, very basic question on ISDN PRI trunk simultaneous call capacity- ex: If I have 2 PRIs from Carrier A : own DID range of 500 Numbers 2 PRIs from Carrier B : got its own DID range of 500 numbers If all the trunks terminating on same phone system and users desks phones have 200...

Thank you for looking into this. The CM is as below... Definity R013x.01.2.632.1

Hello Avaya Gurus, I know its not that easy but wondering what are the steps to move existing ESS from one location to another. The ESS IPs will change. ESS need to again talk to main server. We ordered the telco lines. TIA Forumuser

Thanks again Mitch. Infact, I need to do lot of study on Avaya docs. Iam more into networking than telecom and I inherited the system when our telecom engineer decided to move to another city... but thank you for all your suggestions and time. Thanks Forumuser

Can you check if the policy being downloaded (split-tunnel or Full tunnel) on to his PC when connected. Righ click on the vpn client on laptop (once connected) and you can find this from statistics or some other option (Do not have client in front of me at this time ;-). hth MS

Hello, Make sure the traffic between two subnets is not nat'd and subnets allowed in acls. Also, try by disabling AV on the server. Hth Forumuser

Great.. Thank you.. So after change.. my location information looks similar to 1 8700EST offset 00:00 Rule : 1 NPA 203 2 00:00 Rule : 1 NPA 3 -03:00 Rule : 1 NPA 310 4 ESS_CST offset-01:00 Rule : 1 NPA 312 : This will be...