Recent content by ElHedi

I restarted the Nw services stopped nsrmmd processes without success. The idle device timeout is set but without any effect. Is there any scsi tool that releases these locks?

Hi All is there a way to clear persistent reservation on Tape devices? Sometimes the jukebox cannot unmount tapes saying they are locked by a host although all backup, clone jobs are finished. The only way I succeedto do it is by rebooting the drive. Thank you

Hi SDack, drive access are not on teh same HBA as disks. We have LTO2 drives. We had installed the IBM drivers in non exclusive mode since that time problems began. We reinstalled the same drivers in exclusive mode. The problems seem to be stopped since 10 days. This is strange because EMC...

I have Emulex HBA on server. I have confih=gured persistent binding on HBanyware side, have I to configure persistent binding on OS side too? thanks

Thank you 605 I disabled TUR cleaned drives. things are still the same. Now some tapes, after being written to, become suddently unusable so I tried the following on the same drive nsrjb -l -n -f <device> <volume> : ok mt -f <device> status : ok nsrmm -pv <voulme> : failure this means that...

I am using Adic scalar i2000 I ran scaner -vvv on several volumes I found 65k on devices it is set to handler default I am going to disable TUR. I checcked Zoning it is ok.

Dear All, I have the following configuration : networker server 7.2 on windows 2003SP2 networker dedicted storage nodes : HPUX networker clients windows and linux backing up on the server . I have prematurely full tapes especially on windows and linux and not HPUX. searching on your forum I...

Dear all, I have networker Network edition on windows 2003 with scalar jukebox and IBM LTO2 drives. when installing the driver, I had two ways to install : -exclusive -non exclusive I have chosed the exclusive way. The backup is working fine. But I read on the net that with networker I have to...

Hi all, Is there any way to backup an IBM AS400 using networker, I searched but without any result, have you an experienced with that? thanks

I found that the physical scsi address changes every reboot which makes the jukebox unusable I have to delete jukebox and run jbconfig every time I reboot the server

Dear all, I browsed the forum for threads treating problems like the mine but didn't find. when I reboot the Networker server. it becomes disabled and I cant enable it again so Ihave to delete it and then rerun jbconfig. OS : Redhat AS 4u4 Networker server : 7.3 thanks for the help

a060463xyz thank you very much for your kind help ( it has always been the case) I have tried that and all is working I was looking for any summary if somebody had an experience with backing to two servers before applying it in the customer hosts Things gone very well the special thing I did is...

I think the variable mentionned is not so necessary so we can ommit it and I tried without it things worked fine

May e I havn't to ask here

excuse me i am not asking you to write scripts for neither to adapt a script my question is simple can we ackup to two servers from one clients using nsrnmo using only one script or i have to write two scripts excuse me I didn't have enough time to do all searches i am pressed y time and had to...