Recent content by DQuaN

Does anyone have a download link for this software? Thanks

Just tried HTTPS, same thing.

No from a laptop connected to the same LAN. HTTP.

Still can't make any changes. Any other ideas?

That is not the subnet that the system is on but I think i get your point. I don't think the system is giving out DHCP though.

INSTALLER

I'm going to try installing the Unified Management Console and making the changes through that. Anything I should know?

Just tried basilisk, no change i'm afraid.

Tried IE, Chrome and Firefox. All the same.

Hi All, A customer has an NS700 and the support contact is being very unhelpful. Whenever i try to make a change, to a phone number, name, speed dial, fwd, pretty much anything i've tried, I get "Operation Failed". This is just applying the change on the web interface before I save the config...

Thanks everyone. Downgrading the 406 to 3.0 and setting the expansion modules to 5.0 sorted the problem. :)

Hi All, Here is my situation. A customers' phone system has failed, it is an IP 400 (old i know). It was connected to an analogue and a digital expansion unit. The closest system i had to this one was a 406, so that has gone in in it's place. The system works but the phones connected to the...

This isn't so much of a problem, more a curiosity. We have a dual line setup with ISDN and SIP. We have ARS handle the dial short codes, basically anything that has 00 at the beginning (i.e international) gets sent over the SIP trunk as it's cheaper. Everything else goes over ISDN. Here's...

Yes system status is a great application for administration and diagnostics. It's not a good application for the receptionist to use. Especially as there is a connection limit and if too many receptionists use it, then I cannot connect to it! Call status was a great little app that they could...

Yeah that's what we're using at the moment but it's far from ideal. That's the only solution? Also does anyone know where I can browse some gadgets for onex portal?