Recent content by dbcmaster

That seems to have done the trick.

Does the router setup at least look right?

I am unable to ping from the interface to the router. All the lights on the transceiver are lit that need to be lit to make the connection.

It's like this: Cisco 1751 --> Fiber Transceiver --> Fiber Transceiver --> Sonicwall TZ 180

Hello All, I am having no luck with going from a Cisco 1751 to a Sonicwall TZ 180. Here is my Cisco 1751 configuration: cisco-1751-floor3#sh conf Using 2418 out of 29688 bytes ! version 12.2 service nagle service tcp-keepalives-in service tcp-keepalives-out service timestamps debug datetime...

Hello, I'm still learning this whole phone thing. We have a Merlin Magix system in place. What I need to do is create something so that multiple phones ring when someone calls tech support. So, either from the AA or from a direct transfer, could someone tell me the steps I need to create a...

??

I was able to get the digital lines to ring throughout the company but still can not get the T1 digital line to ring throughout. --------------- PRI -- PRINT --------------- A PRI INFORMATION A Slot 9 Switch: 5ESS A System: By line A BchnlGrp...

I have WinSPM. I am very noobish. If you tell me where to go in WinSPM to get these reports, I can do that for you.

Abbreviated ring did not fix the issue.

It's a Hybrid/PBX with PRI.

Hello, So, I'm new to the telephony game and am trying to understand my companies phone system. Right now, it appears that they have a MERLIN MAGIX system 2.0 v9.0 with MERLIN MESSAGING R2. Right now, when someone calls on the main number, the call rings to all phones. This is how we want...

It appears that I have corrected the issue after reading a manual that I finally found. Corrected the group calling members and change the hunt group to linear instead of circular. Works so far. Still trying to figure out why 7101 was listed as a member in the old 2 port set up.

I did not. How would I do that or check to see if it is done?

Hello All, First off, I'm pretty much a n00b to all this. Currently, the company is running a Merlin Magix 2.0 v9.0 system with a Merlin Messaging system. I just upgraded the messaging from a 2 port to a 10 port card. Now, the message waiting indicator light won't go out after you check the...