Recent content by clementlimpotel

HI Doktor Checked all that. My version of LDK is GS88P-3.69Da DEC12. WTIB Version: 1.0Ah Base Version: 1.0CB You think that could have anything do do with the issue?\?

Hi doctor Thanks, your post is really helpful. I am still having the same problem however. What software would you recommend on the Motherboard? Could this be a software issue?

Hi Hope someone will be able to assist me. I installed a IPLDK60 with a GDC-600B Basestation. I have registered two Siemens Gigaset E495 phones. The registration process went fine. I am experiencing the following problem: Most of the time there is no dialtone on the cordless phone. At time...

Hi Again I need some help with CO Line volume. I have two IPLDK systems that are networked. System A has 4 CO Lines. System B use the CO's from System A to make all outgoing calls. My CO volume on system B's side is very low. However internal call volume to system A is fine. I'm not sure...

Hi again.. Any other advise? I don't have CLI activated from my Telco provider. Does it make a difference. I suspect there could be something wrong with the network numbering plan?

Hi I can set unconditional forward. It works if I forward an internal station from system A to System B, however if I forward the main attendant it still cuts. Here is what happens. I forward station 100 (Main Attendant) to Net200. I can see on the DSS buttons, that when I dial into the CO, it...

Hi I have two LDK60 systems that is networked and I need the first system's CO lines to ring at branch 2 My extension numbers as follows: Branch 1 : 100-147 Branch 2 : 200-247 I can transfer calls between the two and I also use the CO's from branch 1 to make all outgoing calls at branch 2...