Recent content by chanhemow

Hi I have configure Exchange server to receive emails from my public domain using a third part Pop3 connector (popCon). the connector delivers well the emails to exchange server, in in the exchange server emails are not deliverd to the respective mail box the Get-MessageTrackingLog command...

Thank you ShackDaddy

hello does pop connector included in the exchange server 2013? I would like to use it so that my server can connect to my Web hosting company and dowload my emails. My server is installed on Local LAN and my public domain is hosted somewhere else

thanks Telecomboy

Thanks guys for your usefull comments, my point is ; before i connect my box to the service provider what will be the Admin status of the PRI channel by using the System status monitor? should they be in service or out of service?

I am using back to back crossover cable for testing and clock sorce set to CO, i dont have any parameters from provider side as for now the box is not yet onsite. the LED light iw green. I am located in TANZANIA, EAST AFRICA

Thanks guys, as I said it is my first time to install this card in IPO, Now before i connect it to the service provider i would like to check if it is ok within the box, what i face is that the port is inservice admin status but for the channel all shows out of srvice admin status (i guss they...

Hello its is my first time to configure PRI card in avaya ip office r8.1. The situation that i found is that PRI PORT IS inservice while all channels are out of service! is this normal for PRI or something is wrong?

hello i have configured two sip soft phones (X-Lite) and all have successfully loged into CME 3.3 but whey i try to press a call i get the above error! what is wrong?

Telecomboy. i have not enabled the oveflow time as i thought the no answer time will apply. If i have to set it, should i set it for each hunt group ie X, Y and Z or just for X?

Yes snowman50 thats what i have done and it keeps as pointed above. dou you this may be timing isues?

Telecomboy in my setup, i have Y and Z as overflow groups of X, Y being the first in list and Z the second on same list do you mean this setup?

OR snowman50, you mean i should combine the groups Y and Z into same group say M=(Y+Z)?

thanks snowman50, thats what i have done main group X overflow groups Y and Z are listed in the overflow group list of X

i have a setup of three hunt groups, all with these comon settings ring mode: collective overflow mode: call no answer time: 6sec (set to be same as systems no naswer time, also same to individual hunt group members have set that all incoming calls should be directed to first grou say X, then...