Recent content by BlueRiver31

I am using 69.90.168.13. I don't think they use stun though. What firmware version are you on?

Acadacom, They had me set the firwall type to open internet. Are you able to register with Voxitas? Can you receive calls or make calls?

Acadacom, What firmware version are you running on the IP Office? I sent Voxitas screenshots of my configuration for future customers. I will send the screenshots to you but I am not sure what the best way is to get them to you. Who are you working with at Voxitas?

I will give them a try. Thanks for the suggestions. The 1416's are junk in my opinion.

Do you have a suggestion for a replacement model? I used to use the 5400 series before they discontinued them. I am not a big fan of the 1400 series at all.

The issue happens even while just listening to the person on the other end and not trying to talk when they talk.

I have a customer with 1416 phones. They have issues with the volume going up and down when using speakerphone. I have upgraded the firmware from 6.1(5) to 6.1(504) to 6.1(12). None of the three firmware releases has fixed the issue. I have tried replacing the phones and hardware. I checked...

Thanks for the response dphoneguy24. I found some information and talked with the Multitech tech support on the Multitech Multivoip IP gateways.

I have a customer who has 5 locations. They have amplified paging at each site. All 5 sites are linked together with fiber. They would like to avoid installing an IP Office at each location and just install IP phones at the locations where the IP Office is not located. Does anyone know of...

Here is a monitor trace of when a call is made and the issue occurs. 2433531969mS CMCallEvt: 0.55429.0 -1 BaseEP: NEW CMEndpoint f51be0f0 TOTAL NOW=3 CALL_LIST=1 2433531970mS SIP Tx: UDP 10.10.10.11:5060 -> 206.80.67.51:5060 REGISTER sip:stl06a.netlogic.net SIP/2.0...

I have a SIP trunk through Voxitas. I upgraded the IP 500 V2 to 7.0(5) from 6.1(12). After the upgrade I found inbound calls take longer to go through and sometimes the call does not go through at all. Some calls take 45 seconds before the phone on the calling party end will start ringing...

Does anyone know if the 1692 is supported on the IP Office(7.0(5))? Does it require a 3rd party end point? Thanks Michael

Thanks for the information on this tlpeter.

Thanks for the heads up. Do you have a good document on getting a 96XX setup for a VPN?

Does anybody have a lists of which 96XX phones will work with a VPN? I have a 9621 I would like to set up as a VPN phone. Thanks Michael