Recent content by billyj1900

I know you can used the following command for IOS to backup configs. Config t archive write-memory time-period 1440 path ftp://server-ip/path/routername. I need to also have the same results for NXOS. Do anyone know of similar commands to backup configs automatically through...

can you explain what you mean about the correct route?

Cant ping Router 3 from Router 1. I am trying to ping 192.168.1.1 which is F0/0 on router 1 from router 3. Router 1 is just there representing an inside interface of a FW.

I am trying to ping 192.168.1.1 on Router 1 from router 3 and I am not seeing what I am missing. I am trying to use static routes. https://drive.google.com/folderview?id=0B5CZXDXaQgUPc2RyVVlIUzFxQWs&usp=sharing

Do any one know if IPbase supports OSFP? I know it only supports EIGRP stub but what is the limitations on OSFP?The platform is 4500 cat4500e-universalk9.SPA.03.01.01.SG.150-1.XO1.

Do any one know if IPbase supports OSFP? I know it only supports EIGRP stub but what is the limitations on OSFP? The platform is 4500 cat4500e-universalk9.SPA.03.01.01.SG.150-1.XO1.

I have a 4509. Should I be able to traceroute to a vlan ip address? I am also getting erratic pings with a continous ping to all my vlan ip addresses. I am plugged directly in to the blade on the switch hardcoded to the vlan below. interface Vlan30 ip address 10.30.1.1 255.255.255.0 ip...

Sh ethernnel shows the interfaces added in the switch not in the router but if I do a sh int po1 on the router I can see the interface. sh arp doesn't show a duplicated subnet. Yeah I think it is my router or ios c3745-adventerprisek9-mz.124-25d.bin.

I am trying to setup a L3 etherchannel between a switch and a router. The config is below. From the switch and the router I can see each other neighbors but I can ping each other. Does anyone know what I am missing? S1 interface Port-channel1 no switchport ip address 172.16.2.2...

Would this work if the internal routing protocol is using OSPF. Do I have "no passive interface" to both the 4500 and 3750.

Can you provide an example of the load sharing config?

You mention utilizing both links for the internet which is PBR. What about load balancing both ISP links.

1) the 4500 will be primary 2) ATT is the ISP on both connections. 3) I want to do failover. If the 4500 or 3750 goes out I can use the other ISP connections.

I have a 4500 which is connected to a ATT router. The 4500 is connect to a 3750 by layer 2 running HSRP out the 4500. I will be setting up another ATT router off the 3750. ATT will be setting up the BGP. How do I do dynamic routing protocol fail-over with both ATT connections using BGP.

The host is the windows 7 machine. The guest is a VM XP and VM 2008 server. I am using NAT. The ethernet icon says connected and internet. I can ping from DOS 4.2.2.2 and www.google.com on the VMs. But I cannot browse the internet on explorer or chrome on the VM. I changed the active...