Recent content by auEric

I am new to Exchange. We have several domains, all users accept mail for all domains. ie. user@domain1.com user@domain2.com both need to go to user. How can I do this without adding every address?

I use a zero to get a line, then failover is 9 uses voip to remote site. Not automatic but works.

This can be caused by a corupt copy being on your ISPs proxy server. Try another download site or another ISP when this happens, even remove the WWW to trick the proxy. It can take weeks before it is removed from the proxy.

When do the calls drop? At the begining or part way through call?

Using DT, I guess 2.1 something, just got to 21(78) or ? Thanks Eric

I have found free partition progrms risky. If the data is important, I would buy a good program.

I have a 406dt running 2.1(35) connected to this via DSL connections and Cisco routers are several SOE units. All works well except if one site is off line then some or all units will reboot without notice, sometime a few reboots in as many minutes. This is only if a site is off line otherwise...

Thanks for the help, it does seem to work with LCR

It is caused becaus the extns we are having problems with dont have direct indial numbers. I put the shortcode on the user after the telephone number Short Code 0N Telephone Number N .S123456 Line Group ID 0 Feature Dial We use zero to get a line raining cats and dogs here.

Thanks for the promt reply. We need to apply this to some users not everyone. To complicate matters we use least cost routes to select trunks depending on destination.

I know I have read this before, I cant find it and dont remeber what to search for. I need to send my phone number when calling out. We use ISDN lines but are only sending first number of our indial range. I think it was something to do with S prefix some where. Thanks

Can someone advise me if a card is E1 or T1 it has "ASYPCBOSWPRI3000" the sticker Thanks

Thanks I will try 2.1(27) although the ip401.bin file was on the 2.1(35) disk.

I have a 401 Compact Office. When I started I didn't have password or its IP address, so I completly reset it and loaded 2.1.35. That all looks good except it has no password and uploading config fails.

At 2 different sites I have had an SOE dt with LAN & WAN failure. Both were running 2.1.35. The first unit is still away being fixed, should I be able to solve this problem. Is this a common problem?