Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations dencom on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by alose

  1. alose

    2 SLA Monitor sessions on ASA 5505

    I am not 100% on this, it may not even help you, but having tried to do the same thing with ISR firewalls, I had to have 2 devices. One device could only have one default route for traffic. With the use of a routemap you could force some traffic to the other interface but those are not dynamic...
  2. alose

    Power protection question

    Thanks for the effort and assistance Fred, Actually I double checked my setup and we are looking at 30amp on the pdu and 60 amp on the UPS as it is oversized for later expansion. So I guess that is what I am looking for.
  3. alose

    Power protection question

    Generator fits like this: Mains-> Transfer switch and generator-> Main Breaker pannel. Its 125kva and backs up the office. Takes 1-2 seconds to kick in. I had considered wiring both to the ups, and then having a straight wall outlet that I can connect one to as a very manual way of bypassing...
  4. alose

    Power protection question

    All of the devices that are on PDU1 are also on PDU2 so they are UPS Protected on PDU1, if the power goes out they will stay up. I do not wish to put a UPS on PDU2 because it costs more to aquire, maintain, and sucks 5% efficency off the top, not to mention another 5k btu of heat. I am...
  5. alose

    Power protection question

    Ok likely an easy question.I am looking to power my server room like this: 60a 3phase > apc 15kva ups > 3phase PDU1 60a 3phase > 3phase PDU2 Current load aprox 7500w I am parinoid about the power going to PDU2 as it would come straight off the mains. Is there a surge supressor/filter or...
  6. alose

    call's log

    If you want to test it, do it again but with your cell phone number. Call in and if it puts you to nowhere you got it right. (Just remove it when your done)
  7. alose

    Could Use Some Advice

    Thanks for the quick responces. I have solid t1 mpls connections at both sites with dmvpn backup via dsl so connectivity is good. As for just adding IP phones there, for some reason I thought they had to be on the same subnet as a head unit. Do they have to be manualy configured (other than...
  8. alose

    Could Use Some Advice

    I am currently runing IP Office at multiple sites over an mpls. I just got a call from one of my sites that just took over 2 small sattilite sites and wanted to get IP Office at those two sites. Normally I wouldnt ask, but they only want 2-3 phones at each site and a full head unit seems like...
  9. alose

    Voicemail going to incorrect extension

    Thanks all, there was a voip extention removed it and rebooted all fixed. (I had rebooted prior to its removal but it stuck in there)
  10. alose

    Voicemail going to incorrect extension

    Hi all, here is the issue I am having. IP Office 402. A user who used to be at extension 1201 has moved to a new office and now is at extesnion 2312. I changed the incomming call route at the main office to point his did to the 2312 extension. This works, can place and recieve phone calls...
  11. alose

    IP Office 500 Can not hear on Some Outgoing Calls

    I have a site with an IP office 500 running 4.10 with IP phones. All outgoing calls go over a PRI and Internal calls are VoiP to our other avaya sites. All internal and inbound calls are fine. But they are reporting an issue with outgoing calls where they can not hear the other party. (The other...
  12. alose

    Can ping from outside but nothing else (cisco 1811)

    Working with a cisco 1811, 12.4T I copied a config from my other 1811 and fliped the interface rolls. I am able to ping the static nat IP's and get a responce from my home system. But I cant get it to open a web site or start up citrix. Its like it is completly blind to all traffic other then...
  13. alose

    Could use some Advice (Multiple WAN Routes)

    In a Nut Shell: Ok I have 2 internet connections, both with multiple static addresses. I would like to set them up so that I can access a server from 2 different ip addresses. (one from each connection) So that if one of the connections went down, I can still go through the other connection...
  14. alose

    Hunt Group not alerting when user is on a call

    Here are some more details. At both of the sites where this is happening, there are 4-5 members in the collective huntgroup. Both huntgroups have callwaiting on. All of the phones in the Huntgroup are 5410's and non are setup as PoTs. I checked all the lines and they all have callwaiting on. I...
  15. alose

    Hunt Group not alerting when user is on a call

    Ok I am having an odd issue at 2 of my sites. Note this works at all of my other sites. When a member of a hunt group is on a call and another call comes into the hunt group. The call is not apearing in the users second call apearance. This makes it impossible for the user to put their current...

Part and Inventory Search

Back
Top