Recent content by ac1dh3ad

Then how do u explain that i have two interfaces up on 2960 which is l2 switch.

VLAN Name Status Ports ---- -------------------------------- --------- ------------------------------- 1 default active Fa0/1, Fa0/2, Fa0/3, Fa0/4 Fa0/5, Fa0/6, Fa0/7, Fa0/8...

I know that 2950 is a l2 switch and does not have ability to route between vlans. I dont even want this. If you say that it is not possible to create two vlan interfaces with different ips, then i will say that i have two configured on 2960. Suppose i want my switch to be accessible from two...

version 12.1 no service pad no service timestamps debug uptime service timestamps log datetime show-timezone service password-encryption service sequence-numbers ! hostname sw01 ! enable secret 5 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx ! username admin privilege 15 password 7 xxxxxxxxxxxxxxxxxxxxxxx ip...

Hi All, I have following situation, switch 2950 (12.1(22)ea4a) has already default vlan and vlan interface with ip settings. Now i need one more vlan and vlan interface with ip from other subnet. Once i create vlan, vlan interface with ip settings and bring vlan interface up, switch drops telnet...

Hi All, Anybody tried using radius or ms active directory login modules in CW LMS 3.1. I want to get rid of local authentication and setup authentication against ms active directory through radius or directly. There are several predefined local roles with appropriate rights. Some kind of radius...

Hi all, Somebody explains me what do "switch" and "stack" interfaces displayed in port configuration menu really mean. Both of them operate in 10Mbps/Half mode by default, what if i change these values? Never tried though. Thanks.

Hi all, I have noticed that ping results to BayStack 450 within lan are around 20-40 ms whereas pings to any end host within lan are in less than 1 ms. Does it mean that my BayStack 450 is too busy? If so, what should i examine?

Hi, Is there any way of monitoring Cisco clusters using HPOV NNM. Right now it displays only commander switch and interface status. Once suggested to assign each member switch with its own ip and add them into NNM. I am running NNM 7.53 with latest patch NNM_01193 on Windows server 2003 r2...

Please correct me if i am wrong, ers 5500s needs advanced licensing to enable smlt, vrrp, ospf, etc, whereas ers 1600s does not need any licensing to enable smlt, vrrp, ospf, etc. Have downloaded "converged data networks licensing guide" says nothing about 1600s licensing. Thanks.

Thanks guys. Port 20 is disabled right now.

Hi all, I was reviewing BayStack 450-24T logs and came across following entry: Bad port(s) detected, Portmask: 0x7ff7ffff I do understand that something bad with one or more ports on the switch, but which one? May be portmask can help me to identify it. Any help?

Yes, i have replaced one unit in the stack once. Do i simply need to renumber units as they are connected physically?

Hi all, Does stack numbering have an influence on the stack performance? Or it simply mean which next unit in stack may replace base unit in case of failure. I can see following information, Current Unit Number MAC Address ------------------- ----------------------------...

Both username and password should be less than or equal to 15 characters. Although AD allows to create longer usernames and passwords, switch allows only 15 characters to be passed.