Linkswitch 2700 for parts!!! Can't break in to reset!

Here's the breakout when I connect to the serial console, I've tried everypassword combination there was listed in here, as well as taking it apart and trying to reset via the switch near the ATM board.
Bought this on eBay (luckily not for alot) and will have to try to call 3Com (if you can find the number for out of warranty parts).

Anyone else have any thoughts on how to break in?

Thanks In Advance!
Mick

Bootstrap V3.2 Dec 6 1995
LinkSwitch 3Com NCD
============================

Moving the file from FLASH to DRAM ....
Decoding the file ....
Going to operational code ....
Uncompressing file ....
Running operational code ....
...
.
Modem initialization :
ATQ1V1E0S0=3

.

Lo.king for Burn-in test request... not found


Power ON testing ... Please wait
.

LinkSwitch 2700

*** CPU diagnostics report:
*** -----------------------
*** SRAM : 32 K pass
*** Hardware configuration :
*** Utopia - MASTER, TRAM - 256 K, CRAM - 1024 K
*** ZipChip : type ZC2
*** Arbiter : ver 10. 0
*** TM : ver 1. 8
*** Eth. controller: ver 2.0
*** HW diagnostics report:
*** ----------------------
*** TRAM 256 K : pass
*** CRAM 1024 K : pass
*** FRAM 128 K : pass
*** ZipChip Diagnostics : pass
*** ZipChip Initialization : pass
*** Check cells chaining : pass
*** Interrupts diagnostics : pass
*** Ethernet controllers installed 12 : pass
*** PIGGY diagnostics : pass (SUNI LITE/OC3 SC/MM)
*** HW Diagnostics : pass

UART Driver, V1.00, 3Com NCD, 1994

LinkSwitch 2700 Rev 1.0
Software version Ver. 4.00 - Built Nov 16 1998 15:00:23

Select access level (read, write, admin): debug
Password: ******
*** Access denied.

Select access level (read, write, admin): debug
Password: *****
*** Access denied.

Select access level (read, write, admin): tech
*** No such access level, please re-enter correctly.

Select access level (read, write, admin):