ZONES

[PERRYPJ]

I have a MGW with a zone of 20, in the MGW I have a ISDN-PRI that is used for incoming calls. I am trying to make everyone working off the MGW go out the ISDN-PRI, I have a RDB pointing to those trunks. I'm using TGAR and TARG to force the people out that route, but for some reason they won't go unless I change the Zone from 20 to 00. Where is this controlled?

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[allenmac]

Go to Element Manager and look at Zone 20. If the Resource Type field is set to 'Private' then this could be the reason for the blockage. Change to 'Shared', and see if that allows your calls through.

 

[PERRYPJ]

Will take a look tomorrow

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[PERRYPJ]

It was the only Zone that was enabled in the ZDP, modified RLI

OLD ROLMEN WORKING ON NORTELS AND AVAYA