Hi, I recently installed an Iomega zip drive on an NT4 workstation (SP6a). The install went fine, but stopped the modem (USR Winmodem internal) in the middle of a connection. When I rebooted the modem was gone, and the RAS service would not start. I subsequently removed the Iomega software and disconnected the drive, but still no joy. I initially installed the zip disk to backup information on the box, now it can't connect via dial-up. The event logs don't say jack. I think that it may be related to a memory address or IRQ conflict. Can anyone offer any guidance on this problem please? Any help appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Zip drive install prevents RAS from working
- Thread starter damo26
- Start date
xmario2013
IS-IT--Management
go the the control panel modem option see if you can change its com port after installed its software, is that a PCI card ?
- Thread starter
- #3
- Status
