micky500970
Programmer
Hello,
I am very new to zenworks and had very little training. I am currently using zenworks 4. I am restoring an image to an it suite of 30 computers and having problems with two. All the rest have worked fine and all computers are identical.
The problem is that I keep on getting the following message on both computers just after it obtains an IP address, which is the correct ip:
Zenworks is shutting down.
I have gone to console one and made sure that I have chosen the computer and selected use "pxe settings" and then selected "display pxe menu if ctrl and alt is selected". I have also selected "always display pxe menu"
Any ideas would be much appreciated.
Also, one of the problem computers does not show up in the workstations section of console one, any idea how to put it there.
Thanks
micky
I am very new to zenworks and had very little training. I am currently using zenworks 4. I am restoring an image to an it suite of 30 computers and having problems with two. All the rest have worked fine and all computers are identical.
The problem is that I keep on getting the following message on both computers just after it obtains an IP address, which is the correct ip:
Zenworks is shutting down.
I have gone to console one and made sure that I have chosen the computer and selected use "pxe settings" and then selected "display pxe menu if ctrl and alt is selected". I have also selected "always display pxe menu"
Any ideas would be much appreciated.
Also, one of the problem computers does not show up in the workstations section of console one, any idea how to put it there.
Thanks
micky