Zenworks 7 Multicasting

[PhoneTeck]

Im new to zenworks, here is my question.

I have added workstations that have been imported into a workstation group. How would I go about having just the computers that I have specified in this group image when I want them to. I dont wish to setup any rules.

 

[Provogeek]

you need to first create an image object.

Do not recall an ability to assign an image to a Workstation Group Object. You would assign it to each individual workstation. And it would not be multicast, it would be unicast. If you want to do a multi cast from NDS, your doing rules. Other ways of multi cast can be setup at the server console, the your image engine will pretty much be a manual load at the PC. Just setup the multicast to start after X amount of PC's join the session.

=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+
Brent Schmidt Certified nut case
Senior Network Engineer
Keep IT Simple

http://www.kiscc.com